Question about 2004 kawasaki KX 250 F

1 Answer

Have very little power. runs for a minite and then cuts out

Could it be dirty carb

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 345 Answers

Sounds like a dirty carb problem, drain the float bowl if you can, that will save you taking it apart. Also, clean or replace your air filter.

Posted on Jun 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Acts like it's not picking up gas. will run as you spray into carb.


Dirty carb. If it has a fuel bowl take it off and clean it out and clean the fuel jet that has little holes in it. I use an air compressor or a real fine wire.Try this before tearing it apart.

Mar 15, 2015 | Poulan Pro PR625T22RP 22inch 190cc Briggs ...

1 Answer

Generator starts with 1 pull and runs 5 seconds then shuts off. Carb is clean inside.


Must be something wrong with the governor or the links near the carb. Check the springs and linkages. These are usually at fault. If thereafter you still don't find something, must be the jets on the carb. One of it maybe a little dirty.

Jul 07, 2014 | Makita G6100R 5800 Watt Generator

1 Answer

Tractor starts and runs...dies if you cut choke, accelerate, or just leave it running a min


sounds like carb jet is dirty. need to remove and clean carb internally. watch a couple videos on how to clean lawn mower carbs on youtube first to get an idea.

Sep 07, 2013 | Husqvarna Garden

1 Answer

Honda 5.5 hp stops


Honda had a problem with the gas cap not venting properly, but commonly it will run for several minutes at a time before stopping. 30 seconds sounds like possible fuel delivery problem like a sticking float or dirty carb jet..especially if you have to run it with the choke on. A bad air filter...very dirty, or oil soaked might do this. Check your oil level. Sitting, oil is a little higher level than when running and these motors will not run if the oil level is too low.

Oct 18, 2012 | Briggs & Stratton Gas Pressure Washer...

1 Answer

Hi, my pc just shuts down after 10 to 15 minites as if there was a power cut then i put it back on it will not last 5 minites but if i leave for a few hours it will last for 10 to 15 minites again. can you...


From the information desribed it appears that your PC is over heating. You may need to clean all the vents especially the fan vents with an air duster (can of compressed air).

It is possible that your fan(s) has failed or is running slow - they might need replacing.

Also make sure you operate your laptop on a solid surface so that air can freely circulate under and around it.. I hope this has helped

Jul 30, 2011 | Computers & Internet

1 Answer

My car cuts off when I stop, and it hesitates, and it has a loss of power


Mass air flow sensor is dirty. It is located on the top of the engine near the air intake. It has three screws that hold the cover on. Clean with a little brake cleaner or carb cleaner. It builds up carbon, but when you clean becareful not to break the little wire that is in there.

Aug 28, 2010 | 1995 Pontiac Bonneville

1 Answer

Motor has to be cranked alot to start and then when you push up on the throttle for more power it runs just above an idle , and dosent rev up all the way


Your carb. might be out of adjustment. There is a rod and another rod with a spring on it going from the carb. 2 an arm on the side of the motor. With the motor running, push the arm a little towards the carb. If it revs up, its out of adjustment, if not, you have a dirty or bad carb. Clean or replace the carb. If that doesn't work, your keyway might be cut or broke. The keyway is what keeps the motor in time so everything works together. Like a timing chain or belt on a car. Good luck.

Jul 09, 2010 | Craftsman 675 Series 190cc 22" Briggs ...

1 Answer

Makita G11oo portable generator. starts on choke. cuts off run


Just noticed your question... If you still need a little help:
1. If the gas is from last year, drain the tank and the carb bowl and replace gas with new. Visually inspect the inside of the tank ..be sure there's no sediment that needs to be cleaned out.
2. remove air cleaner and make sure it's not plugged or dirty
3. plug the spark plug and clean with spray carb cleaner.
4. At end of season, mix some gas stablizer in with the fuel to keep it from going bad while in storage.

Let me know how it goes..
k

May 21, 2009 | Makita 1,100 Watt 2.5 Hp Portable Power...

3 Answers

YAMAHA CYGNUS X CUTTING OUT


Happened to mine as well. Took 3 or 4 visits to the dealer before it finally happened when they were test driving, as before they did not believe me and thought i was running out of fuel! Turns out the fuel pump was faulty and was replaced with unit of different spec as the original type pumps were overheating and cutting out. The pump would work again when it had cooled down. The new different spec pump has worked fixed everything and now the scooter has not missed a beat. This should be fixed under warranty.

Mar 14, 2009 | 2003 Yamaha YZ 250

Not finding what you are looking for?
2004 kawasaki KX 250 F Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...