Question about 1996 kawasaki VN 1500 Vulcan Classic

1 Answer

Cluth is sliping on my bike when u give it gas is there a way to adgust it so it dosent slip

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 46 Answers

If there's any adjust ment left, you can adjust down where it attaches at the cluch lever on the right side of you bike using a wrench, but if the cable is already at the max, then you'll need a new clutch kit which is relatively easy to do with some basic hand tools. Loosen your clutch cover bolts and remove the cover then remove the clutch basket and reinstall new friction disc's and clutch plates in exact same order as old one sit's in there. Then fill'er back up with some fresh oil and adjust it out. Be sure to leave a little free play at the lever. Good luck.

Posted on May 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My chain is sliping on my26" Mongoose Ledge 2.2 Men's Mountain Bike


Its usually a bad freewheel. Its a complex operation to replace, contact local bike shop for assistance

Jul 15, 2014 | Cycling

1 Answer

Honest john car problems


if your towing something heavy it could cluthe sliping try car without towing if ok then check what your towing is free wheeling and not to heavy

Apr 21, 2014 | 2007 Land Rover LR3 V6

1 Answer

I just bought a 2004 Honda Shadow 600cc that had been sitting for a while. When I pull the choke the engine will idle but as the choke hits the middle the bike dies. also once its running I have to ride...


Sounds like you have a float sticking in your carburetor, is this a single carb or a duel carb? , also gas can go stale and your bike will run like **** if it also has been subjected to tank condensation and water in your gas, that also maybe your problem, I would drain the tank and drain the carb or carbs, and start off with fresh gas and would use 89 octane or better, also pickup some StarTron Enzyme gas treatment, it will stabilize your gas for up to 2 years, and remove the ethanol from your gas, that is a bad for your motor, try it you will never go without it. Good luck, Rick.

Aug 06, 2011 | 2004 Honda VT 600 C Shadow

2 Answers

1983 honda gold wing 1100 ,120,000 klm,runs great .When should one be doing a clutch change?


If you go easy on the clutch and do not pull a trailer, you may never have to replace the clutch. My GL1000 clutch has over 150,000 Miles (around 240,000 km) on it and works just fine

May 09, 2011 | 1983 Honda GL 1100 Innerstate Gold Wing

1 Answer

Slight sliping in third gear when accelerating hard. Does clutch need replacing


If it is the original clutch I would say probably to check for sure go about 35mph put the bike in top gear 5th i believe on your bike give it full gas if the bike revs fast clutch needs repacement

Jan 30, 2010 | 1996 Suzuki VS 1400 Intruder

1 Answer

When im going up hill my jimmy loses power i give


yes i could be slipping.try manually shifting down going up hill.

Jan 15, 2010 | 1997 GMC Jimmy

2 Answers

How do you adj this cutch it just started sliping 2006 yamaha roadliner s 18000 miles


if it is cable operated you want to adjust at the clutch perch (where the lever is mounted on) to where you have about an 8th inch of play before you feel the tension of the clutch in the lever. if that dosent do it change your oil if you havent done so already and if that dosent do it then the clutch is probably toast.

Jul 29, 2009 | 2006 Yamaha Roadliner S

3 Answers

196 cc baja mini bike dies if I try and give throttle


Well i had the same Baja mini bike and to be honest with you, you will run into alot more problems with that bike bec they build them so cheap, I and alot of others had 1 thing go after the other on that modle and to me they just aint worth the trouble or money, But check the coil and make sure to

Jul 21, 2009 | Mini Motorized Bike

Not finding what you are looking for?
1996 kawasaki VN 1500 Vulcan Classic Logo

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...