Question about 2005 Suzuki Boulevard C50

1 Answer

Removing the rear tire - 2005 Suzuki Boulevard C50

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

What about it ?????

Posted on Aug 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing rear wheels


you dont need to remove tires from bike, turn bike on one side so back tire is flat to ground, this give you the other tire in air for easier access. Use a tire removal kit to take off tire there relatively cheap, try walmart, they usually have the tires and the removal kits too...

Mar 28, 2012 | Schwinn Meridian Adult 26-Inch 3-Wheel...

1 Answer

Remove rear tire


It should be rubber. I use a pair of piers and gently twist till comes off. Then there e-clip to remove. Remove tire.

Jan 20, 2012 | Craftsman 42 in. Deck 19.5hp Lawn Tractor

2 Answers

Where is the spare on the 1997 Blazer


Welcome to FIxYa.com


rear of truck under neath frame


Regards, Lee Davidian


Thank you for using FixYa,com.

Oct 23, 2010 | 1997 Chevrolet Blazer

2 Answers

Where is the spare tire located on a 1995 ford aerostar?


Section 00-02: Lifting, Jacking and Spare Tire Stowage 1995 Aerostar, Ranger, Explorer Workshop Manual
TIRE STOWAGE Tire, Spare, Removal, Aerostar If the Aerostar is a standard length vehicle the spare tire is mounted inside to a carrier at the left rear quarter panel. To remove the spare tire, remove the wing nut and plate. A flat tire can be temporarily stowed in the same location.



If the Aerostar is the bus with a standard length body or extended length (all models), the temporary spare tire is stowed at the rear of the vehicle under the body. The Aerostar standard length E-4WD bus spare tire is mounted on the floor.
  1. Insert lug nut wrench into the actuator hole and turn counterclockwise until the cable extends to allow the spare tire to be pulled rearward from under the vehicle.
  1. Slide spare tire to the rear and remove the retainer from the wheel.
  1. To stow cable/retainer with spare tire removed, insert cable fitting into carrier rear wall slot, place wheel retainer against the carrier, and turn lug nut wrench clockwise until slack is removed.
please rate, thanks

Jul 09, 2010 | 1995 Ford Aerostar

1 Answer

How to remove the rear tire with shaft drive


Pull the rear axle, and spacer on the brake side of wheel. Un hook brake rod and brake strut. Position yourself on the brake side of the bike and pull the rear wheel straight out of the final drive housing. Put a little grease on thhe final drive splines upon reinstalling the wheel to aid removal next time.

Apr 01, 2010 | 1979 Yamaha TX 750

1 Answer

How do I take the rear tire off of a 2004 kawasaki nomad


I hope you have a jack... I had to remove the pipes and bags on my 04 vulcan nomad so I remove the cotter pin and pull the axle out of the rear hub. Then removed the spcer and rear brake. slide wheel assy. out of the drive hud on the left (removal of brake and spacer allow this) and drop the tire down. It's not hard...

Sep 21, 2009 | 2004 kawasaki VN 1500 Vulcan Classic

1 Answer

Change rear stud bolt on rear tire


take tire off, remove drum , hammer out old one. with nut and spacers turn nut to pull stud in hole.
If vehicle has rotor. remove tire, remove brake caliper, remove center axle nut, remove rotor. hammer out old. install new one

Jul 27, 2009 | 2002 Dodge Caravan

1 Answer

Removal of motorcycle rear tire/shaft driven


The final drive assembly has to be unbolted from the swingarm and it is removed with the rear wheel. Once the assembly is off the bike, the axle can be removed and the final drive separated from the wheel.

Jul 16, 2009 | 2005 Yamaha V Star 1100 Classic

1 Answer

1977 honda goldwing rear tire removal never had


Get a service manual.
there are two ways to go. both time consuming and of moderate difficulty.
My favorite is to remove the trunk, saddlebags, rear fender as a unit. Then the tire is in the open to work on. Not an easy job.

Jun 06, 2009 | 1982 Honda GL 1100 Gold Wing

Not finding what you are looking for?
2005 Suzuki Boulevard C50 Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...