Question about 1982 Honda VF 750 S

Open Question

Battery warning light bypass. resistor size?82 vf750s. put in new battry w/out sensor.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Charging Warning System and Immobilizer indicator warning light is both on after my 2004 Kia Amanti is running and put in drive.


Was the battery unhooked recently, Alternator or battery could be faulty, you can check them with a digital meter. The Immobilizer light may go away after you adress the battry/charging fault.
link to your manual below.

http://www.kia.ca/content/ownership/ownersmanual/2004_amanti_Owners_Manual_EN.pdf

Mar 08, 2016 | 2004 Kia Amanti

3 Answers

When start the engine all the lights are blinking


NEVER remove the battery cable when the engine is running. It can damage the alternator and a lot of other electronics on the vehicle. The alt will go to the full charge mode. Most all of the dash warning lighs shut off thru a circuit that goes to the alternator. Check your wiring for loose connectors or a grounding wire.

Dec 31, 2013 | 2000 Mitsubishi Montero Sport

1 Answer

Phone full battery but wont turn back on


may be battry is outdated or extra fully charged thats why sometimes it react like this or the size also bigger than normal battry so try new battry or check the PIN which is connected to battry when u put battry in mobile...thank you

Nov 03, 2013 | Samsung Galaxy Pocket

1 Answer

Z24 nissan engine 720 kingcab sensor light is on.what sensor?


An orange or yellow light with just the word "sensor"? All '82-'87 models are equipped with a maintenance reminder light for the oxygen sensor. It is just an alert to have the O2 sensor checked. Light is set to come on at 30,000 miles, will need resetting, then will again come on at 60,000 miles, must be reset, will come on at 90,000 miles at which time Nissan says locate and disconnect warning light connector. Be done with it!

There are two methods to turn the light off, depending on model, year, and engine size and calibration. On the earlier systems (without a relay) the connection for the warning light is somewhere around the fuse box-wire colors are different for all models, so I can't help you there-you just disconnect the connector.
Later models may have a sensor relay. Relay is reset by depressing a button on the relay or by inserting a small screwdriver into the reset hole-depending on which kind of relay. Getting confused? Not done yet, so you may just want to find the warning light connector, unplug it and be done with it-you probably have more than 90K anyway, at which time it should be disconnected
But to continue: Now, you have to find the relay for resetting...Good luck on that!...I can tell you, though, that on pulsars and sentras, the relay is located either behind the left kick panel or the right kick panel, can be in either location, depending on model and year. Your pickup, if it has a relay, should have it also behind one of the kick panels.
But if you can find the warning light connector, 2 wires, just disconnect it. It might also be near the hood release handle.

Sep 30, 2013 | Nissan Cars & Trucks

1 Answer

Battery fully charged but warning light


has your battery being replaced new one might not have sensor if so you can fit a 50 k resistor between the positive terminal and sensor wire located next to the battery this will stop light flashing

May 25, 2010 | 1992 kawasaki GT 750

4 Answers

How do you know with direction to put the battries in as their is no markings, Does it not have a polarity?? also how many and what size battries does a GVD -505A Live Wire take


Just changed my batteries 2 LR44 batteries positive side goes toward the back of the device, There are no markings on the holder to determine polarity!

Mar 15, 2010 | Acer Gardner Bender GVD-505A LIVE-WIRE...

2 Answers

How do i know when to replace batteries ?


There's no sure way to know when to change the batteries. I'd suggest you change them at least once a year. Plan on it when you do your smoke alarm battery change, which should be done at least annually.

Jan 26, 2010 | Weiser Lock Powerbolt 1000 Lock

1 Answer

Camera will not turn on...charged battery but the charge light blinks instead of staying solid


If battries still blinking , chances are that the battries are buggred...try new battries after fully charging...this is cheaper option to try before trying to open the camera..

May 20, 2009 | Casio Exilim EX-Z77 Digital Camera

1 Answer

Battry warning light


The battery warning light indicates that you have a problem with you charging system, more likely your alternator. As you speed up the engine requires more power from the coil and is probably draining your battery. If the car still starts, try taking it to a auto parts store such as autozone. They will check your charging system for free.

Apr 29, 2009 | Pontiac Sunfire Cars & Trucks

2 Answers

Value Stack Flue Sensor


3.5 to 4K If you want to bypass the sensor just jump a 1 dollar resistor in between the two wires. If you want to put another sensor just use a standard gas heater flute sensor(2dollars) and put in line with the resistor

Feb 07, 2009 | Sta Rite STA-RITE SENSOR,FLUE TEMP -...

Not finding what you are looking for?
1982 Honda VF 750 S Logo

Related Topics:

505 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...