Question about 2000 Harley Davidson FXD Dyna Super Glide

1 Answer

2000 flstc engine light comes on after start up

2000 flstc engine light comes on after start up and stays on everything seems to be normal oil charging etc what should i check?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Harley Davidson Expert
  • 119 Answers

Has your battery gone dead recently? There are several things that can set an engine fault code and honestly due to that Id say take it to your local dealership and ask them to flash the codes for you, most of them will do this for free as it only takes a minute to walk out and hook up with the tool to do that. In some cases all it takes is for the motor to not start one time properly and you'll get a misfire code that simply means it was out of cycle when it fired the cylinder and as long as the bike is running fine, Im guessing that is what you had, however be sure get the codes flashed. Good luck

Posted on May 30, 2010

Testimonial: "I was at the hd shop sat and they said the same thing bring it up and they would reset it thanks"

  • Harley Morris
    Harley Morris Jun 06, 2010

    you are very welcome anytime and Im glad to hear that all is well for you have a great riding season.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2000 FLSTC. After about 20-30 min of riding, the check engine light comes on and the speedometer stops working and/or is spiratic...jumps around. The check engine light comes on and off, and sp


It sounds like you may have some pinched wires r other wiring problems since the apes were installed. What are the other eledtrical issues you have had??

May 18, 2014 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Check engine stay all the time 2005 mercury mariner


Hello,

There is a lot of things that cause a engine lite to stay on.

Here is just a few things, that will have engine light stay on:

Service is due, some cars have that automatically do this when time for regular service.

Breaks, Some cars have a sensor that after a certain range on your pads, it triggers the service Light.

Oil Low, or water/antifreeze low.

Emission problem, Like fuel filter needs replacing or possible 02 sensor not working ( part of your Cadillac converter)

Battery not fulling charging, or alternator not putting out proper amps. etc,,

This list can go on and on, most the time if you have low oil, or break issue, there is separate warning lights for that.


Here is what I think, sometimes when you have something wrong with your car, if you checked your oil level, water/antifreeze level, breaks seem good, and all your other fluids are good, and your car is running good and as normal, what best to do, is take it in and have them put it on there computer, this will tell you if there is something your over looking, by normally a code that comes up on there system. Sometimes the code will come up on there computer and not on your dash warning lights. Auto Zone, normally can do this for free with there hand held computer and tell you what comes up and what to check out. And all Garages if everything is ok, can with computer turn your engine light off if everything is ok. But for sure get it checked, and don't just assume it is a faulty engine light coming on, most the time there is a reason. Thanks Mike

Sep 13, 2011 | 2005 Mercury Mariner

1 Answer

Oil light on nissan altima (2000) after oil change in addition since oil change noise comes for engine and check engine light on


I HAD THE SAME PROBLEM & IT WAS 2 MUCH OIL ,I TOOK A 4th of A QUART OF & EVERYTHING WENT BACK 2 NORMAL.

Jun 18, 2010 | 2000 Nissan Altima

1 Answer

Driving normal, at 80 kms, car seems to studder a bit, (gas wise) engine light comes on. Stop car, re-start, everything fine, no engine light, at 60 kms, fine, get up to 80 km, engine light comes on and...


First try replacing air filter if not done recently $30, next consider bad fuel put in fuel from major oil company from station with many patrons.Then you need to look at fuel delivery system including fuel filter and furl pump. But first try the 2 things mentioned.

Jan 22, 2010 | Land Rover Freelander Cars & Trucks

2 Answers

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil....


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the readings still jump around you have a pump that is getting weak and failing, If that is the case the pump should be replaced, but with high milage you may consider rebuilding the entire engine. If the readings stay normal start checking for a loose wire at gauge or sender. Then check sender, then gauge and replace as needed.

Oct 02, 2009 | 2003 GMC Envoy Xl

1 Answer

Flashing engine light on a 2000 FLSTC Heritage Softail


You should have your engine codes read to pinpoint exact problem location. It may be faulty sensor or other electrical problem or leaky vaccuum

Aug 25, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Fuel injection light on dash


when your bike is cold,,and after it warms up ,doe sit continue to idle high ? Then replace your temp. sensor located on the top of the front cyl....

Jun 11, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Red oil light stays on 1/10 of mile after starting engine


Did you check the oil level?? Which i am guessing you did, it everything is running good and no change in engine performance or bad noise's coming from the engine. Then it's going to be your oil pressure sending unit, the oil pressure sending unit is inexpensive and you can pick it up at Auto Zone far less then the dealer and Auto zone will have the step by step instruction to replace the oil sensor. It's going to take just under an hour or less depends on how long you want to let the engine cool down before you work on it. Good luck and hope this helps. keep me posted, be glad to help.

Jun 08, 2009 | 2003 Chevrolet Express

Not finding what you are looking for?
2000 Harley Davidson FXD Dyna Super Glide Logo

305 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...