Question about 2005 Kymco Grand Dink 250

Open Question

Water pump leak of kymco dink 150.how do i repair

My kymco dink150 water pump is leaking,how do i repair it?and also there is noise under everytime i accelerate.is it the water pump?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 50cc kymco scooter starts but when you pull the throttle back it cuts out


Hi, Christopher and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Bike idles perfect but dies when given the slightest amount of throttle 93...
starts idles stalls giving gas Scooter Doc Forum
scooter dies if give it throttle
http://www.scootermasters.com/manuals/kymco%20People%2050-complete.pdf

Aug 27, 2016 | Kymco Motorcycles

1 Answer

My kymco 50cc starts but when you go to throttle it it cuts out can you help


Hi, Christopher and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
http://www.scootermasters.com/manuals/kymco%20People%2050-complete.pdf
scooter dies if give it throttle
starts idles stalls giving gas Scooter Doc Forum
Bike idles perfect but dies when given the slightest amount of throttle 93...

Aug 27, 2016 | Kymco Motorcycles

1 Answer

My kymco zing 2 has started leaking fuel from somewhere under the tank is this a common problem?


anything that has a plastic fuel tank in it is a common problem 4 leaks !! I've had brand new chainsaws , tractors, and yep even bikes come in here with fuel drips !! its them plastic fuel tanks everytime !! they jjust cant take the chassis flex the ole metal ones could (but then again ive never seen plastic rustout either ) and they get small cracks in them right where they attach to frame most times too !!

Jul 29, 2016 | Kymco Motorcycles

3 Answers

I have 2000 grand am gt Ive been having a water leak problem for a few weeks now everytime I start my car I have to full with water and in the midst of trips usually needs water also I noticed it getting...


where do you live. Never put straight water in a radiator even during the summer. Do you see any leaks around the water pump, radiator hoses, or in the passenger side floor inside also at the firewall where the heater hoses go into the heater.

Apr 29, 2017 | Cars & Trucks

1 Answer

When pump runs it is very loud


depending on the noise, it could be cavitating, due to air leaking into the inlet side, or it could have faulty bearings. If its a screechy noise, then probably bearings.

Dec 10, 2013 | Goulds Pumps 1HP J10 Deep Well Cast-Iron...

1 Answer

Squeaking noise and antifreeze leaking....waterpump replcement perhaps?


With the engine turned off, put your finger up behind under the pump pulley. if you find antifreeze there likely the pump seal has failed. Otherwise, locate the leak source and make whatever repair is necessary. You will get a noise any time water or coolant gets on the drive belt. Best to look before going through a pump replacement to find later you have a pin hole in the radiator on a hose!!!

Dec 30, 2010 | 1996 Jeep Grand Cherokee

1 Answer

I have a grinding noise coming out of the engine which increases with acceleration. It sounds like a water pump but there is no leaking water. Also the fluid level for the power steering pump is correct,...


ok check the ballbering polea the one thigten the belt if is not that then is the ACcompresor ballbering some times is the water pump take a garden water house cut just about 1.30 meters and turn on the engine and use it in one in your ears and the other end close to the poleas and you will listen the noise were come from be careful could be dangerus if the belt teke the house

Jan 19, 2010 | 2001 Isuzu Rodeo

2 Answers

Everytime I add coolant or water it instantly leaks bach out under the SUV. It trickles down the oil pan to the ground. Is this leaking from the water pump?


betya booties is is the water pump.try adding water while engine is running ,if the rate of leakage seems less ,it is definately the water pump. iwould take it to a radiator repair shop andthey will check for sure i doubt they will charge you as it only takes aminute , good luck.

Aug 01, 2009 | 2006 Kia Sorento

Not finding what you are looking for?
2005 Kymco Grand Dink 250 Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...