Question about 2006 kawasaki EL 125 Eliminator

1 Answer

Bike stalls when clutch is released - 2006 kawasaki EL 125 Eliminator

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Check your cluth adjustment , adjust if possible .

Posted on May 27, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

REPLACED CLUTCH ON ZR 550 CLUTCH ENGAGES , BUT WHEN FULLY RELEASED BIKE JUDDERS THEN STALLS OUT . TRY TO ADJUST & GEARS WONT ENGAGE .


So if you raise the revs to say about 4000 rpm and let the clutch out does it stall or judder or both will it engage at all and pull away ?

Mar 07, 2015 | Motorcycles

2 Answers

Stalls when put in gear


Does it yerk forward, if it does that it could mean that the clutch is not set correctly or it it does not release correctly

Mar 31, 2014 | 2006 Triumph Speedmaster

1 Answer

Bike jumps when on release of clutch in first gear and stalls


The clutch plates are probably rusted. I ride the bike with the clutch lever pulled in until very warmed up and keep blipping the throttle at low speeds in first gear this sometimes releases the stuck clutch.

Jan 12, 2014 | Motorcycles

1 Answer

Bike stalls when clutch is disengaged


If you mean it cuts out when in gear and you release the clutch to ride off, then I would check the sidestand switch.

May 29, 2012 | 2008 BMW G 650 Xcountry

1 Answer

Hello I have replaced the clutch plates,the release cylinder seals and rebuilt the clutch master cylinder. There is no leaks and the system has been bled and it feels fine. When I pull the clutch lever in...


Back wheels often move when the lever is pulled in...this is due to hydraulic drag caused by the oil on the clutch plates and is totally normal. You should be able to stop the wheel by hand with the lever in.
With the lever out the clutch is fully engaged and the engine will therefore stall with the brake on...
As long as the wheel rotation can be stopped by hand with the clutch pulled in it's behaving normally...
Rocking the bike in gear is a method that's used to seperate the plates on a clutch that is dragging...usually if it's not been used for a while.

May 06, 2012 | 1987 Yamaha FZR 1000

2 Answers

1983 honda gold wing 1100 ,120,000 klm,runs great .When should one be doing a clutch change?


If you go easy on the clutch and do not pull a trailer, you may never have to replace the clutch. My GL1000 clutch has over 150,000 Miles (around 240,000 km) on it and works just fine

May 09, 2011 | 1983 Honda GL 1100 Innerstate Gold Wing

6 Answers

Stalling problem from neutral to first gear


Hi and welcome to FixYa,

Initially, if the bike will be run without its own battery, the engine will really stall. This is because there will be no consumer for the voltage output other than the ignition system which will clamp down when the engine is revved and the voltage tends to go higher still.

Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Nov 27, 2008 | 1984 Yamaha XS 400 L Maxim

Not finding what you are looking for?
2006 kawasaki EL 125 Eliminator Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...