Question about 2005 Suzuki Boulevard C50

1 Answer

My TPG scooter stops all of a sudden like I have braked

My TPG 50cc Akros scooter stops all of a sudden like I have put the brakes on and then the motor stalls. Then it will run as normal again for about 1km then same problem. I thought the starter motor may have been engaging so I took it off but no change. Possible something in the drive train. The engine runs fine until this happens so I don't think it is the engine it self.??

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Two things you might need to check...your..belt or your brake pads condition.when it hots it expands and clamps, might need replacement.

Posted on May 26, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to refuel a sym jolie 50cc scooter, do you mix oil into the petrol tank, or do you fill the oil and fuel seperatley or does it mix it itself????

Pretty much all are normal petrol in the fuel tank and the oil is on another tank. The oil is mixed as it enters the inlet manifold.

Your manual is here. Section 2-3

Nov 06, 2016 | Sym Motorcycles

1 Answer

Ford Excurtion will start normal, but stall when putting in gear (reverse) or braking. When re-starting it runns ok until next braking.

Have the catalytic converter checked at your local muffler shop...clogged...worn out...Hope this helps.

Mar 12, 2014 | 2005 Ford Excursion

1 Answer

2003 nissan frontier stalls when i slam on the brakes

Check oil level, but might be idle motor going bad. The idle motor kicks down the idle as needed as the rpm dictates. If sudden reduction in rpm occurs the idle motor normally keeps up and motor continues running at reduced idle. Unless its going out on you, then you may experience stalling when speed is suddenly reduced such as hard braking.

Mar 16, 2013 | 2003 Nissan Frontier Crew Cab

1 Answer

50cc taotao scooter the carb is runs then fills with gas untill it stalls out dont get much off the searchs i have made dont no if it is the carb our choke broke down carb and looks clean no clogs or

My 2012 Taotao 49cc scooter was spitting and sputtering then just died one day. I brought to a small engine repair person and come to find out, the hoses that came off the carb had cracks in them. Changed the hoses and the problem went away. Hope this helps.. I have since replaced the cheap hoses with new ones from the auto parts store and never had the problem again.

Oct 21, 2012 | Star 50cc scooter for kid

1 Answer

What happens to my brakes if the motor fails on a Pride scooter?

the motor will automatically brake the scooter to stopped and keep it locked there until it is running again or put manually in neutral.

Apr 28, 2012 | Pride Mobility Products Health & Beauty

3 Answers

I was driving my 50CC scooter down the road today when suddenly i lost power. after stopping i started the scooter again, turned the handle to go and nothing happens. the engine sounds fine and revs up,...

Your drive belt snapped. If it is a 50cc, 4 stroke engine, chinese scooter, with a 10 inch rear wheel, then you most likely need a 669-18-30 belt. That is the most popular scooter belt on the planet and is available for about $10-$35, depending on the quality you want. Any scooter shop can change it for you. It only takes about 15 minutes, but expect to pay a chargeable labor rate of .5-1hr since there are unexpected problems occasionally, and there is cleanup time, paperwork time, etc. It should cost about $30-$75 in labor plus parts. Any more than that and you are getting ripped off. You may have other worn parts in your transmission such as roller weights and variator guides. These tend to wear out on chinese bikes around 3000km+. If they are worn, change them while the technician is working on it. It shouldn't cost you any more labor, just the parts, about $12-$20 for the rollers, and $8-$12 for the guides. Cheap belts last about 2000-3000km, good belts last 5000-9000km. Pay the extra few dollars for the better belt, you won't regret it. If your belt broke prior to 2000km, then you may have a defective part in your transmission, such as the rear pulley. That usually comes as a "clutch pack" and generally sells for $40-$90. If you have more than 2000km, it probably snapped just from normal wear and tear. If you can't find a local scooter shop, you can reach us at We can ship you any parts you need. This repair is not recommended for novices. Although it is easy for those who know how to do it, you can damage your crankshaft and ruin your motor if you do it wrong. Hope this helps.

Jul 17, 2010 | RTO 50cc Moped Scooter

2 Answers

50cc stop working after three miles, brand new, delivered today

have you checked that the spark plug is tight and that the ht lead is on the spark plug?

May 05, 2010 | RTO Gas Motor Scooter

2 Answers

50cc Two Stroke Scooter Engine - Poor Idle

I had the same problem- from out of nowhere the scooter started dying at every stop. I adjusted the idle screw to 2000 and it still idled up and down. I bought some injector cleaner but this will take a while to work (several tanks of gas) and then found this link- seems to be a very simple thing to do once you read this link. I hope it helps. --

Mar 14, 2009 | Toys

1 Answer

Sudden stops

Sounds like the brake. Ohm chech the brake (it is attached to the end of the motor). It should be around 35 ohms

Jan 04, 2009 | Golden Technologies Avenger 3 Wheel...

Not finding what you are looking for?
2005 Suzuki Boulevard C50 Logo

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

80668 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4999 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides