Question about 2006 kawasaki ZZR 600

1 Answer

Replaced clutch the new clutch is not in gaging after replacing

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • kawasaki Master
  • 3,433 Answers

1st would be adequate free play-No free play clutch is not fully engaged. 1/4 inch free play needed at clutch lever.

2nd would be oil type. Motor oil is a no no. Wet clutches hate regulat oi. Must use oil specific to the bike. Good luck

Posted on May 25, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

3.8 liter replaced a/c compressor 2years ago this year compressor clutch not engaging has freon could it be low pressure switch is bad?

Has Freon? How much Freon? The low pressure switch has a threshold and you need to use a gage to see what it is. You can bypass the low switch to see if the compressor clutch engages.

May 13, 2016 | 2008 Chrysler Pacifica

1 Answer

99 chevy s-10 2.2l the temperature is slowly increasing

if you have electric fans, make sure they are working and that there is sufficient coolant in the overflow tank and radiator. If you have a manual fan clutch, try spinning the fan with the engine off, It spins freely or goes around more than once with just a quick push, your fan clutch is bad and needs to be replaced. and it is a fan clutch...not a clutch people sometimes call it.

Aug 02, 2012 | 1999 Chevrolet S-10 Pickup

3 Answers

Replaced the ac compressor but now no power to compressor but have power to low and high pressure switches. checked relay under hood, relay and fuse in cabin. what am i missing?

Put a jump wire in the high pressure switch plug. If the compressor works. replace the high pressure switch. Let me know and we can go from there.

Aug 22, 2011 | 1999 Ford Expedition

2 Answers

Replaced ac compressor and dryer and evacuated the system, and i can't refill the the system the clutch won't engage?

you can jumper the low presser switch to in gage the clutch until you have enough freon in the a/c unit to keep the Freon low presser switch in gaged.hope this helps.

Apr 29, 2010 | 2001 Chrysler Town & Country

1 Answer

My fly wheel to the air conditioner dont move on my 2003 kia sedona

There is no fly wheel on the AC compressor, however there is a clutch assembly that in gages and dis in gages when the Ac is turned on, if it does not spin when the A/C is no it is most commonly caused low refrigerant in the Air conditioning system. The system will have to be tested for leaks and repairs made and maybe a low pressure switch replaced in order to fix this.

Sep 28, 2009 | 2004 Kia Sedona

2 Answers

What is causing my 99 ford f150 to overheat while on the highway

try washingthe raditor at a car wash wash thre the engine compartment to the outside. clean the ac fan condensor then check that the fan is not loose next replace the anitfreeze if it's more than two years old, and the radiator cap if it still does it replace the thermostate gasket, these are the most common problems for over heating. you could have a clutch fan bad too but do the other stuff first it's cheeper.

Jun 21, 2009 | 2004 GMC Sierra 2500

2 Answers

Do i have to pull my engine to replace the clutch?

hi, i think the engine has to come out because the gearbox will not clear the subframe, i seem to remember doing one years ago and we had to take it out, hope this helps!

Feb 04, 2009 | 1987 Subaru Gl 4WD

1 Answer

1992 bmw 535i


Sounds strange. If the water pump was really replaced, then they should have replaced the thermostat (which often causes such problems), also only correct thermostat must be used. (best bought from the dealer)
The only other thing I can suspect is the head gasket damage, but I would double check the thermostats first.

Hope this helps!

Sep 26, 2008 | BMW 535 Cars & Trucks

1 Answer

Air conditioning

what gage reads high? the red or the blue gage?

Jun 08, 2008 | 2000 Ford Explorer

Not finding what you are looking for?
2006 kawasaki ZZR 600 Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides