Lost keys to sandleford electronic ES20 N15115 tried to open but batteries are almost flat and just keeps beeping do i have to wait for a replacement key to open Jeff Amos

Install fresh batteries.
Press reset button on left side of door (may be covered with protective plastic cap), beep will sound.
Enter new 3-8 digit code, press * or # key, green light will come on to confirm new code accepted.
Manuals are available at https://www.sandleford.com.au/sandleford-manuals

Google it and buy a new one. Then get back to us.

http://downloadfromthisblog.net/69777-sandleford-electronic-safe-n15115-manual.html

i forgot my combination to my 15115 sandleford safe how do i open it

I have a new N15115,ES20 electronic safe,it will not accept a change of password.when new password entered it only beeps once ???

lost key know code cannot open

149 then A key
or try 149 and B key

these codes can be turned off tho if i remember in the manual...

if it works open dor... press down red button located inside the thick door kinsid the unit.. it beeps.. type new code and A

test to see if it works.

oh and throw it away

This document might be of help - you'll have to determine which is your proper setup.

http://www.sentrysafe.com/pdfs/OwnersManuals/IntBarracudal.pdf

The operating instructions on the ES20 as per the crappy manual:

Open safe using emergency key provided

Insert batteries in the box inside the door

Opening the safe
a. pre-set factory code 159
b. input 159 (the yellow light will flash and the buzzer will beep), then press B or A button, the green light will be on, rotate the knob clockwise, pull outwards, the door is opened

Closing the safe: close the door, input the code (the green light will flash for 5 secs). Turn the knob anti clockwise, the control system will activate and the safe will be locked

Changing the code: open the safe, press the red button located inside the door, the yellow light will go on indicating the code can be changed. Input the new code (1-8 digits), then press A or B button, it shall be confirmed by two beeps indicating the new code has been accepted and stored. If the yellow light and buzzer beeps 3 times the code is invalid - try again

Emergency Key - store in secure place NOT inside the safe. Remove the override cover in the centre of the face of Safe (its a silver plastic panel with Sandleford Electronic Safe ES20 on it), insert override key (a cyclinder key) - hidden underneath the override cover panel - and turn anti clockwise, rotate the knob clockwise to open door

Changing the Battery - If the red and green light are on this indicates that the batteries are low and require changing. To ensure the batteries have been installed correctly test before closing the door

References:
1. Operating instructions EA Electronic Safe
2. http://www.secustar.com/products-en/estype-safe.htm

have just had the same problems if you had the key there is a red button inside the door to reset the code but obviously no key no red button I have the sandleford number to call 03 97750699 or try the factory pre set 159 A or B see how you go