Question about 2008 Keeway Outlook 150

Open Question

The engine temperature is usely very hot - 2008 Keeway Outlook 150

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2007 equinox as soon as i start my car is said engine hot ac off ,but car is not hot someone help


You need a new thermostat in your engine now if your getting sluggish engine performance and its over heating you might have a blown head gasket and hello 2 grand mechanic bill :(

Dec 30, 2014 | Cars & Trucks

1 Answer

What causes hyundai Elantra 2002 tempature gauge fluctuates between normal and hot


The thermostat "seals" the cool coolant giving up (rejecting) heat in the radiator & heater core from the hot coolant absorbing heat in the running engine "block".

When the coolant in the engine reaches a specific temperature (180 ~ 195 degrees) as determined by the value selected by manufacturer or when replaced, it opens and allows the hot coolant in the engine block to be pumped out to the radiatot & heater core for cooling and the cool coolant in the radiator / heater core is pumped into the engine block - replacing the hot coolant. The thermostat senses cool coolant in the engine block and seals shut until the temperature of the coolant in the engine block rises to 180 ~ 195 degrees again. This process continues over and over for as long as needed.

You should check to make sure that the coolant level in the reservoir / radiator is sufficient by checking when cold. Do NOT remove a radiator cap when it is hot! With the cap off, start the engine and add additional coolant as the engine warms up to normal operating temperature. If coolant levels are ok, the trouble could be related to the thermostat or possibly a faulty temperature sending switch. This means that the temperature of the coolant is fine - but the switch or sensor that converts the temperature to a voltage for the gauge on yur dashboard is the problem.

If the temperature is fluctuating up and down, you should have it fixed. Good luck!

Apr 12, 2013 | 2002 Hyundai Elantra GT

1 Answer

Overheating with AirCon ON, OK with Aircon OFF


if engine over heating coolant over flow jug will boil over you will see steam.sound like you have either faulty engine coolant temperature sensor or could have faulty fans relay or fuse or pcm problem if coolant fans dont turn on.have garage with code scanner that can do a snap shot on coolant temperature sensor check see how hot coolant temperature is see if coolant temperature over 220 degrees engine getting too hot.could have faulty water or blowed head gasket check engine oil on oil dip stick look milkly you have blowed head gasket. i use infra red laser thermometor check see how hot engine is over 107 celsius engine is overheating.

Dec 10, 2012 | 2000 Toyota Sienna

2 Answers

Temperature light came on...what to do or what does it mean????


Generally the temp light means the engine is too hot assuming its the light for the engine.
Check the fluid level in the radiator and the overflow tank, and see if the radiator fan runs when the engine warms up.
Could be a problem with the thermostat too if the engine is running hot.

Jul 06, 2012 | 2008 Dodge Charger

1 Answer

Engine fan won't come on


IF COOLANT FAN FUSE AND RELAY OKAY.HOT WIRE COOLANT FAN TO SEE IF FAN MOTOR OKAY.IF FAN MOTOR OKAY.THE ENGINE COOLANT TEMPERATURE SENSOR MORE LIKELY BAD.THE ENGINE COOLANT SENSOR WHEN ENGINE COOLANT GETS HOT IT CAUSES ENGINE COOLANT TEMPERATURE RESISTANCE TO DECREASE CAUSE COMPLETE CIRCUIT IN WHICH POWER FROM PCM TO ECT SENSOR WILL SENT POWER TO COOLANT FAN RELAY THEN CAUSE COOLANT FAN TO TURN ON. HAVE ECT SENSOR OR ENGINE COOLANT TEMPERATURE SENSOR CHECK USING CODE SCANNER TO MAKE SURE ITS WORKING BEFORE SPENDING EXCESS MONEY.

Jun 18, 2011 | 1998 Ford Taurus

1 Answer

Where is the temperature sensor for the temperature gage


Engine Temperature Sensor Operation:00116_engine_temp_sensor.jpgThis sensor monitors the temperature of the engine and sends that information to the engine control computer to regulate the amount of fuel needed - more if engine is cold and less if it's hot. The signal generated can also be sent to the temperature gauge as a visual indicator of overheating and imminent danger

I checked with autozone.com and their site says that the engine temperature sensor is not used on both engine sizes available for this vehicle.

The Coolant Temperature Sensor is used though. So maybe it has a dual purpose on your vehicle.

Coolant Temperature Sensor Operation:00113_coolant_temp_sensor.jpgThis sensor monitors the temperature of the engine and sends that information to the engine control computer to regulate the amount of fuel needed. More fuel is needed if the engine is cold; less if it's hot. If the temperature is extreme, the signal will be sent to the temperature gauge as a visual indicator of overheating and imminent danger.

Because ECT (engine coolant temperature) sensor procedures vary depending upon their location, first locate the part. You may need to partially drain the engine coolant to prevent coolant spillage.
  • Disconnect the negative battery cable.
  • Unplug the ECT.
  • Then, unscrew it.
  • Reverse the removal procedures to install the new part.
  • Connect the negative battery cable to the battery.









Nov 03, 2010 | 1995 Chevrolet Caprice Classic

1 Answer

1996 sunfire overheating replaced thermostat, waterpump and heater core. Fan is working after cleaning relay. Still overheating ?


Does the top rubber engine to radiator hoes get hot? If yes then the new thermostat is working. Does the bottom return hose from the radiator back to the engine also get hot? If yes then the pump is OK. If not then there is a blockage in the system and this will need to be flushed out from both the radiator and the engine block using a high pressure hose. Does the radiator fan come on promptly. It should start before the bottom return hose becomes hot. If not then the temperature sensor (different from the temperature sender to the dash display) maybe at fault. Your relay maybe fine but it is the sensor that actually triggers the fan to come on. It may be just bad connection so try wiggling the wires to it when the engine has got warm. The temperature sensor is also important to let the engine computer management system (ECU)know that the engine has reached operating temperature. A failed sensor not only allows overheating but means that the ECU thinks the engine is still cold and runs the engine on a rich mix. Have you noticed lumpy idling when hot and excessive fuel consumption recently? these are symptomatic of a failing sensor.

Jul 13, 2010 | 1996 Pontiac Sunfire

2 Answers

Radiator fan not working


CHECK FUSE AND RELAY.IF ALL IS GOOD.HOT WIRE COOLING FAN USING JUMPER WIRES.USING CAR BATTERY.IF FAN RUNS.ITS GOOD.IF FAN DONT RUN.REPLACE FAN ELECTRIC MOTOR.ALSO SCAN IT. TO MAKE SURE COOLANT TEMPERATURE SENSOR IS NOT OPEN.MAKE SURE ENGINE COOLANT TEMPERATURE SENSOR AND COOLANT TEMPERATURE READS SAME ON SCANNER IF NOT REPLACE THE COOLANT TEMPERATURE SENSOR. SEE IF COOLANT TEMPERATURE IS BAD THE COOLING FAN OR FANS WONT RUN.

Sep 07, 2009 | 1997 Plymouth Voyager

2 Answers

Engine coolant indicator


make sure that your fans are working first. to do this. start veh and let idle until it warms up. but if it starts to get hot and fans do not turn on, check fuses. if they work then look for leaks.

May 20, 2009 | 2001 Toyota Camry

Not finding what you are looking for?
2008 Keeway Outlook 150 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keeway Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Ron Stone

Level 2 Expert

197 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...