Question about 2006 Gilera Runner VRX 200

Open Question

"3, 10" code on a 2008 Gilera Runner ST 200.

I have a 2008 Gilera Runner ST 200. It was struggling to start for a couple of weeks but eventually did start each time. It has since stopped turning over, and the dash momentarily displays a "3, 10" code. Any ideas?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: my gilera runner vx 125 wont start

i had the same problem if i remember correct it was a T shaped connecter for 3 tubes that had snapped cost about 50p

Posted on Mar 08, 2009

  • 3 Answers

SOURCE: my gilera runner 07 plate 50cc wont start

any 2 stroke oil

Posted on Apr 18, 2009

  • 3 Answers

SOURCE: misfiring at speed on gilera 200 scooter

This sounds more like a lean fuel condition than ignition. If it was stored over the winter without the gas being drained or a fuel stabilizer being added, you'll likely have varnish build-up in the fuel system that is not allowing sufficient fuel flow.  If your engine is fuel injected, it's likely your injector is partially clogged.  If it's carbureted, your carb jets may be partially clogged or your carb float may be sticking and not allowing the needle valve to fully open.  Fill the gas tank with fresh gasoline, but leave enough room for a can of Sea Foam.  The Sea Foam may be able to break up the deposits and allow fuel to flow again.  However, there's no guarantee and the fuel system may have to be disassembled to be cleaned.

Posted on May 05, 2009

  • 1 Answer

SOURCE: cannot find the spark plug on runner 200

If your Sitting on your bike. Its on the right side. The (silver) panel that is covering or surrounding the pillions footrest. Unscrew 3 small screws and one large one behind the pillions foot rest. Remove panel. Look into and downwards, you will see the wire that is connected to the spark plug. I just changed my plug today :) Hope this helps.

Posted on Sep 15, 2009

dtci80
  • 125 Answers

SOURCE: my gilera runner vx125 2008 front lights

Sometimeds it's like this: left is normal beam and right is high beam or similar...
so in that case it might look like it's failing,
otherwise check your fuses, check the wiring, check the lightbulb....

I hope this is helpful, and greetings,

Olivier.

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi could you please tell me how to locate the oil pressure sensor on a 2013 Gilera runner st4t thanks


Hi, Daniel for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Gilera, despair not, for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
GILERA RUNNER 125 SERVICE MANUAL RUNNER 200 WORKSHOP Download Manuals... $10
Gilera NEXUS 300 Owner Manual
http://www.gileraspares.co.uk/spares/choosemodel.asp?make=GILERA

Oct 12, 2016 | Gilera Motorcycles

1 Answer

My gilera st200 hard to start in the morning..recently just change spark plug and battery..still the same..any idea what is the problem


Hi, Fazer and the usual suspects are:
1. Spark plugs in bad condition or have an improper gap or are partially fouled.
2. Spark plug cables in bad condition.
3. Battery nearly discharged, should have 12.5 volts.
4. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Throttle controls not adjusted correctly.
6. Water or dirt in the fuel system.
7. Water or dirt in the carburetor.*
8. Intake air leak.
9. Fuel tank vent hose and vapor valve plugged, or fuel line closed off, restricting fuel flow.*
10. Enricher valve inoperative.*
11. Engine lubricant to heavy (winter operation).
12. Ignition is not functioning properly (possible sensor failure).
13. Faulty ignition coil.
14. Valves sticking.
* Carbureted models.
For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
Starting problem Twist Go Magazine
Thread ST200 Runner owner 2009 2010
Modern Vespa Help with my Gilera VXR runner please
GILERA RUNNER ST125 SERVICE MANUAL RUNNER ST200 ST 125 200 Download...

May 08, 2016 | Gilera Motorcycles

1 Answer

My gilera runner 125st 2008 when started and throttle is pulled back it just dies the power goes


Hi, Mark the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, 9 volts or lower.
2. Faulty alternator/generator and or voltage regulator.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Faulty main circuit breaker or ignition switch, check for loose connections and continuity.
5. Faulty system and or ignition relay, check for continuity.
6. Faulty ignition coil, ignition/electronic module.
7. Faulty CKP, CPS, CMP, MAP, TPS, O2, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Water or dirt in the fuel system, carburetor or filter.
9. . Restricted, blocked or kinked fuel line.
10. Fuel tank empty.
11. The gas cap is not venting properly or fuel tank venting system blocked.
12. A faulty Fuel Pump, pressure regulator and or fuel injectors.
13. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
14. Needle and seat stuck closed in the float bowl.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
https://www.tradebit.com/filesharing.php/search/0/2008+gilera+runner+st+125

Aug 15, 2015 | 2008 Gilera Runner ST 125

1 Answer

What model/type of battery for gillera st 200


Are you talking about a Gilera Runner ST 200? I'm not familiar with a mobility scooter by the name you mentioned. If you do mean the Gilera ST 200 you can find a replacement battery and info on the battery itself on Amazon.

Piaggio Gilera 200 Runner 200 2010 2012 YTX12 BS Sealed Maintenace Free...

Jan 14, 2015 | Health & Beauty

1 Answer

Greetings! I have a 2009 gilera runner 200st. With an engine temperature halfway on the gauge and on idle while waiting for a green light in an intersection, the rpm would drop as it seems to be runni


Clean plugs new fuel new battery. If you change one thing at a time you will know the problem. Lasts seasons fuel is the biggest culprit then it clogs up the plugs and delivers. Just dump the fuel.

Oct 21, 2014 | 2009 Gilera Runner ST 200

1 Answer

Gilare runner st 200 my 2008 runner 200 st won't start after heavy rain.


The ignition components are getting wet and the Ignition charge is being discharged down the side of the wires and not through the spark plugs are required. The next time it does not start in the wet, try spraying all the spark plug wires with wd40 and if it fires up, replace the ignition wires.

Nov 18, 2013 | Motorcycles

1 Answer

Gilera runner 125st acceleration problem


First check it is a 125 cc engine. And not a 50 with a 125 body and stickers on it. If it is the 125 then check the timing (ignition) as this will be controlled by a box full of electronics and if only one component fails it could give the same symptoms as you describe.

May 17, 2013 | 2009 Gilera Runner ST 125

2 Answers

Gilera runner 125 st 2008 cuts out by arcing


coil lead plug cap needs replacing , no shield to protect spark plug from getting wet due to weather/water splash. electrical spray lubricant requires from damp start problem

Dec 29, 2012 | 2008 Gilera Runner ST 125

2 Answers

Wanted carb for gilera.180/200 runner. dna 180. 4stroke engine


Have you tried bob wright motorcycles they are based in westernsuper-mare but they are a gilera stockist new and used parts and offer mail order check them out on the web.

Jan 13, 2010 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
2006 Gilera Runner VRX 200 Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gilera Experts

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Are you a Gilera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...