Question about 2004 Honda CRF 450 R
My water pump on my 2004 CRF 450 leaks how can I stop it?
Hi, Lanepitts48 for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
crf450 leaking from weep hole coolant
Dirt Bike 04 08 crf450 Leaking Water Pump Rebuild
Honda CRF450X 2005 Service Manual
Honda CRF450R Owner Manual
Posted on Jun 28, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It means your water pump seal is seeping at this point. Eminent failureportended. Replace water pump. Seals on pumps usually fail because of bearing wear, so this is a precursor to pump shaft failure. Good luck
Posted on May 27, 2009
Chances are the air filter is extremely wet. Air can't get through a wet filter, and if no air can flow through the carb, no gas can flow through either. Remove the filter and try again to get the engine started. I assume you drained and cleaned the gas tank already. If still no joy, remove the carb and clean it using spray carb cleaner. Remove the air screw and throttle screw and spray into the screw holes as well as all the little drill holes in the carb body. The object here is to clean out the pilot jet and idle circuit. When re-assembling the carb, put the air and throttle screws back in and turn them inward until they LIGHTLY seat. Now open each of them up one and one half turns. This is the factory setting. Please rate my answer.
Posted on Feb 23, 2010
yes sir the seal hole should not be oblong, was the bearing bad when you took it out? sounds like the shaft has worn out the hole.
Posted on Apr 08, 2010
Tips for a great answer:
Apr 14, 2013 | 2002 Honda CRF 450 R
Jul 04, 2012 | 2004 Honda CRF 450 R
Jun 15, 2011 | 2005 Honda CRF 450 R
Apr 17, 2011 | 2002 Honda CRF 450 R
Dec 22, 2010 | 2004 Honda CRF 450 R
Apr 08, 2010 | 2005 Honda CRF 450 R
Feb 25, 2010 | 2004 Honda CRF 450 R
Nov 05, 2009 | 2004 Honda CRF 450 R
Jul 27, 2009 | 2004 Honda CRF 450 R
May 27, 2009 | 2003 Honda CRF 450 R
59 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: