Question about 2003 kawasaki KX 125

1 Answer

Hiii i have a kx85 i was just driveing nxt fing u no it was bogging dwn then it cut out then i tryed kicking it n the kickstrat gone stiff i dno wah 2 doo any ideads

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Sounds something like the engine may have seized, tho sorry no other ideas.

Posted on May 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have kx 85 an powband doesn't kick in I put new govner in an full rebuild can u help


Hi, Frankee and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
kx85 2003 won rev out
03 KX 85 Powerband Problem Kawasaki 2 Stroke
http://www.kawasakimotorcycle.org/forum/kawasaki-motocross-offroad/148673-03-kx85-powerband-wont-kick.html
bike bogs when it hits the powerband Kawasaki 2 Stroke
Kawasaki KX85 Service Manual

Sep 03, 2016 | Motorcycles

1 Answer

Hi there, i got a 5150 half stack amp and the evh wah pedal, my problem is when i engage the pedal comes a terrible hum, i already change the cables, 9v battery and the ac adapter and the big noise...


WHY are you using a battery AND a 9 Volt adapter? This is an either/or thing. Chances are you have a defective ground someplace. Use just the battery and try it... If the hum is gone, the adapter is NOT compatible with the pedal. A lot of hum problems occur because the guitar is near a source of magnetic fields, such as an amp. An embarassing thing is for a musician to reverse the in and out connections to the pedal... it will have the symptoms you have mentioned.

Apr 24, 2011 | Dunlop EVH Wah Wah Pedal Wah

1 Answer

Engine cut out whilst driving along and it wont start now


check the vacuum hose from the inlet to the brake reservoir.......

Jun 07, 2010 | 2000 Alfa Romeo 145

1 Answer

RM85 w/ 105 kit bogs down with rapid throttle onset rate


hi buddy set the needle clip to its normal condition and also on the carb is the mixture screw you need to turn this all the way in and out 1 turns and try this you will always get a bog if you rev fully too quick i had this problem with my kx85 and it was just this hope this helped mate i will send the pic in a mo

Sep 17, 2009 | 2004 Suzuki RM 250

1 Answer

92 xj6 starts fine but when step on the gas engine bog dwn andbackfires


how many miles on vehicle??? could be s fuel problem but i have also seen the ignition coils dry up and have similar problems,try the coil first,its ALOT cheaper,hope this helps

Sep 05, 2009 | 1992 Jaguar XJ6

2 Answers

Cutting stair stringers with circular saw


the start of the cut is starting to close up and pinch the back of the blade once you have gone past centre,if the blade is past the starting edge you can tap a small wedge into the start of the cut and that will stop it .I AM AN EXP SAW PERSON TO PROVE IT I ONLY HAVE A THUMB, AND ONE REATTATCHED FINGER ON ONE HAND .that happened on a bench saw only the back of the saw blade lifts the wood and for some reason i pushed it back down,DUMB ..Be careful and think before you do , But a wedge will solve your problem

Aug 19, 2009 | Saws

1 Answer

Bog when trying to mow


you are cutting to much grass & it isn't kicking it out fast enough out of deck which will bog it down it might help if you clean out the bottom of the deck & also dont cut really low if grass is really tall also cutting wet grass will aslo cause the bogging if i can further help e-mail me wade at wadembly@aol.com

Jun 26, 2009 | Garden

2 Answers

Engine cut out now it wont start.


hi mate i got an kx85 but haver never come accross this problem check the reed valves are not sticking and check to make sure the exhaust port is clear not full of carbon build up also check air filter is clean not cloged good luck

Mar 10, 2009 | 2006 kawasaki KX 125

2 Answers

Nokia 5310 speakers


Probably U have spilled Ur coffee on the speaker holes on the battery cover...
Rush to a repair center they will try to save it, but I'm not sure about the display.
If it is damaged U have no options than replacing the display...

Nov 22, 2008 | Nokia 5310 Cellular Phone

Not finding what you are looking for?
2003 kawasaki KX 125 Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...