Question about kawasaki Ninja 250R Motorcycles

1 Answer

I have a ex 250 ninja i want to make it a little louder how can i do it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 338 Answers

I am assuming you have the stock exhaust you want more noise or actual increase in power, you can buy an after market performance system just check online there are plenty of systems out there for you to choose from they make more noise and increase performance.

Posted on May 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 Ninja Kawasaki 250 but I no longer have the keys for it. I tried taking off the gas cap to get a copy of the key but it wont come off. Now I took off the 8 screws that keep it in place. Once...


I used to have a 87 EX 500. Just about the same bike.
It locks to the inside edge of the fuel tank and it seals tight so its not going to come off.
If you can load the bike in a pick-up and find a locksmith that can cut a Kawasaki key, they can be pretty good at cutting a blank. They may also be able to pick it and then make you a key.

Aug 26, 2011 | 2005 kawasaki Ninja 250 R

1 Answer

2002 ninja 250 idels good runs bad with no power band and sounds like its running on two cylinders but both exhaust pipes get hot,it just doesnt sound like a ninja should,i put new plugs with no change


The power band on a 2002 Ninja 250 does not kick in till you hit about 5000 RPM. The newer 2008 and up 250's kick in about 3000 RPM. There is a website devoted to the Ninja 250 that might give your more background into the motorcycle: ninjette.org You may want to replace your spark plug caps they may be robbing of the spark you need at take off. They simply unscrew off of the end of the wires. They should read 5000 OHM's no higher , no lower. If you purchase new NGK brand plug caps they will only cost about $5 each.

Jun 05, 2011 | 2008 kawasaki Ninja 250R

2 Answers

Where can i find the serial number on my kawasaki ninja 250?


Frame number(VIN) is stamped on the yoke behind the headlight. You have to turn the handle bar fully in order to see it on the frame. The engine number is stamped on top of the lower half of the engine behind the cylinders (basically on top of the gearbox)

May 19, 2011 | 2007 kawasaki Ninja 250R

1 Answer

Hello I have e ninja 08 250 and in the morning when is a little cold, I used the ckoke but the iding doen't go up.What i should do ?


My 2009 does not idle up right away either . I usually just hold the slightest pressure on the throttle for 10-30 seconds till it idles up or starts to idle by itself. Like my Honda's the ninja is cold blooded and just likes to be tended when cold. I only have 600 miles on mine so I have not had a lot of experience with this model. A good source of information can be found on the website : ninjette.org.

Dec 30, 2010 | 2008 kawasaki Ninja 250R

1 Answer

Would the fairing parts of a 2006 kawasaki ninja 250 fit a 2005 kawasaki ninja 250?


Yes I do believe they do. Try going to Powersportseast.com Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul

Nov 02, 2009 | 2008 kawasaki Ninja 250R

1 Answer

Weak idol and leaked anti freeze.Help


doess the antifreeze come out when not in overheat? sounds like a head gasket. Open radiator cap, engine cold and running. If you see bubbles, you got troubles

Jul 11, 2009 | 2008 kawasaki Ninja 250R

1 Answer

Need vacum line diagram for 2003 ninja 250 ex


the dealer ship can print that out for you at no charge or should.

May 30, 2009 | 2008 kawasaki Ninja 250R

1 Answer

2001 250 ninja


make sure you are checking the timing using the number 2 cylinder, no the number one.

Feb 24, 2009 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...