Question about 2005 Suzuki Boulevard C50T

3 Answers

I have trouble keeping my c50 2005 Suzuki idling...had the TPS replaced and cant keep it running at Idle consistantly. Have been back to the shop twice, but bike will still die....sometimes it will idle fine, but 90% of the time it dies at intersections.

Posted by on


3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem the michanic told me it has a bad berring

Posted on Nov 10, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.


    An expert whose answer got voted for 20 times.

  • Expert
  • 75 Answers

Sounds like it is fuel-related, but....if you have never adjusted the valves, it may be part of the solution. Not easy, but most experience a performance boost, particularly at idle, if they were not within the range.

Posted on Aug 18, 2010

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

  • Contributor
  • 3 Answers

Hi it sounds like the bike is set to rich

Posted on May 06, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

97 tacoma runs a few seconds and dies. will stay running if you keep foot on gas for a few mins then let off. crankshaft sensor code, replaced it but still get code. could it be iac or tps

If the code for the crank sensor comes back, then there's still a fault in that circuit. Check for sensor resistance and wiring harness short or open. Crank sensor resistance should be 1,630 -2,740 ohms when cold. TPS would not cause those symptoms. IAC could cause rough idle but wouldn't affect higher RPMs. Bad coolant temp sensor could also be part of the problem. Bad sensor = ECM thinks engine is warmer than it is and provides too lean a mixture. But fix the crank sensor issue first since that affects the fuel injectors.

Dec 04, 2017 | Cars & Trucks

1 Answer

Suzuki jr80 takes too long for rpm to get back down to idle , after throttle is released. wasnt run for couple yrs. completely disassembled carb and cleaned. it starts 1-2kicks.not setting correctly?

Hi, Troy and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Lazy Slow Return to Idle or Erratically High Idle
2 Stroke suzuki JR80 tuning help
OEM parts for Suzuki
Suzuki DS80 and JR80 Motorcycle Cyclepedia Online Service Manual
Suzuki JR50 Owner Manual

May 25, 2017 | Suzuki Motorcycles

1 Answer

1990 wrangler with a 4cyl was dying at idle found the vac line to the map sensor had a crack replaced it and reset the computer. Still dies at idle and now cuts out at higher rpm. Have to fan clutch th...

It could be a combination of 2 things. A faulty MAP sensor itself or a bad TPS (throttle position sensor). It's not uncommon for a bad TPS to idle when the motor is cold but once warm, not idle fast enough to keep the vehicle running.

Jul 18, 2011 | 1990 Jeep Wrangler

2 Answers

Replacing TPS cant get it right car keeps revving up and down on 85 celica supra

Hi, if the problem is at idle, it may be caused by a clogged PCV system. The idle controller needs the PCV flow to maintain a steady idle. Remove the PCV valve and hose and clean them with carb cleaner until you can get a good flow thru the system. Please let me know if you have questions, and thanks for using FixYa.

Feb 22, 2011 | Toyota Supra Cars & Trucks

2 Answers

I have a problem with my Suzuki idling too low when in gear 500 rpm--1000 in park, then dying when in gear and at a stop--It does this sometimes and then stops for a week. It will run fine for a while and...

induction clean,(that means intake manifold clean inside)sometimes that area throttle body, and intake manifold get contaminated , and make that problems (low idle) . take it to you mecanic and ask for; throttle and intake manifold service. on the ignition switch spray some w40 in where the key goes.. ( if you want to do the clean service yourself go get intake manifold cleaner at the autoparts and follow the instructions (how to apply it).

Mar 02, 2017 | 2001 Suzuki Vitara

1 Answer

I cant get my rm 125 to idol

But it runs fine other wise? as long as you keep it above idle runs fine but then dies at idle? id so then you need to clean the carbs the slow jet is dirty. hope this helps

Jun 27, 2009 | 2003 Suzuki RM 125

1 Answer

Car will not Idle

The TPS must be set with a voltage meter. What are the code numbers? Air flow meter will not let it idle too. Get a used one to save you money. Be sure you do not have the ecm number 1228253 in it also,they will make the car shut off while driving. I have one of the cars with 295,000 miles on it.

Jun 26, 2009 | 1990 Buick LeSabre

2 Answers

98 lincoln cont. idle speeds up in park...sometimes keeps climbing to around 2500 rpm...sometimes idle is normal though. If in drive and idle is climbing, can drive without using the accelerator!

I had the same problem. I changed the throttle position sensor (TPS). I haven't had any trouble since I replaced mine about three months ago.

Dec 22, 2008 | 1995 Lincoln Continental

2 Answers

2003 dodge ram p/u 1500

I would think the idle speed control valve is defective.

Sep 16, 2008 | 2004 Dodge Ram

Not finding what you are looking for?
2005 Suzuki Boulevard C50T Logo

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

78267 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4731 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides