Question about 1986 Yamaha RD 350

1 Answer

My 350 banshee 2006 wont start real good, but once its warm starts first kick every time. what could it be.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 224 Answers

Sounds like you need a valve adjustment.

Posted on May 10, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yfz350 banshee kick start bound up


pull the kicker case cover, probably something simple jammed up in there...if you didnt break her in keeping revs under 2000rpm for 10-20 hours you may have broke something internal again, lets hope not

May 22, 2013 | Yamaha 2005 Banshee Base

2 Answers

Why is my Yamaha Banshee is hard to start


It looks like your compression is too low (worn rings from dusted motor) Push starting spins the motor faster than kick starting and when hot the rings expand just enough to seal off. Before kicking a cold motor try putting in a squirt or two of engine oil in the plug hole to see if there is a difference.

Apr 26, 2013 | New Ray Ray 1/12 Yamaha YF 350Z Banshee 06

2 Answers

Kawazaki kdx 125 wont start


KICK HARDER TRY PULL STARTING IT..IN SECOND GEAR..DOES IT HAVE ENOUGH COMPRESSION TO START?IT SHOULD START PULLING IT...START OFF WITH NO THROTTLE THAN IF NOT STARTING CRACK THE THROTTLE SO LIGHTLY AND SHE SHOULD FIRE OFF WHILE IN GEAR BEING PULLED OF COURSE BE CARE FUL NOT TO RUN INTO. WHO EVERS PULLING YOU..USE A LONG TOW ROPE..IF YOUR NOT A SEASONDED RIDER AND KNOW YOUR BIKE VERY WELL I WOULD NOT ATTEMPT THE PULL START...IF NOT CHECK YOUR COMPRESSION AND TIMING..MAJOR VACUUM LEAK MAYBE AT BASE GASKET..IS ENGINE SUCKING TO MUCH AIR? GOOD LUCK..

Mar 02, 2013 | kawasaki KDX 125 Motorcycles

1 Answer

Can you test the voltage regulator on a yamaha banshee


The voltage regulator on a Banshee only controls voltage output to the lighting system.Checking is easy... unplug one headlight, attach voltmeter to ("low beam" hot wire) and ground wire. Start engine. AFTER warming the engine quickly rev engine close to redline (bout 9000rpm). At 9000rpm, voltage to the headlights should NOT exceed 16.3 volts. It it does... it's cooked.

Nov 14, 2011 | 1986 Yamaha RD 350

1 Answer

I have a 06 banshee with fmf pipes it won't start


sounds like your rings are shot, Prob only runs at high rpm & dies when gets lower and wont tick over, try kicking it over slowly with your foot can you feel the compreesion cycles , if not defo rings

May 27, 2011 | 1986 Yamaha RD 350

1 Answer

2006 f350 super duty diesel start good in the mornings but after is warm it wont start.


these trucks use a oil fired fuel injector, if your high pressure oil pump has eccessive wear or if your oil to broken down from being run to long between oil change, it will not build enough oil pressure to fire the injector once the oil is thinned out from being hot. An oil leak in your high pressure oil system can cause same problem.

Jan 11, 2011 | 2006 Ford F 350 Super Duty

1 Answer

04 crf450.hard start when cold(25deg).kick for 10min.once it


1. First thing is when was the last time you had your valves adjusted
2. On cold start up twist about 15 times on your throttle, as you do that the accelerator pump in carb will shot gas in cylinder, I have a 2003 yx426 & 2005 yz450 have to do to both of them when cold out to get started





Feb 07, 2010 | 2005 Honda CRF 450 R

4 Answers

Banshee wont rev


Usually related to TORS, specifically the safety switch in the clutch/park brake assembly. If it's defective the engine won't rev. Solution: look for a TORS removal kit.

Jun 16, 2009 | 1986 Yamaha RD 350

1 Answer

2001 Yamaha Banshee that won't stay running


If your jetting is too rich it will be extremely hard to kick start it and will most likely flood it from kicking.First thing i would do is pull the top of the carbs off (cable,slides and needles) and see which clip they're set at. If they are set stock which would be middle clip then lower the needle one clip. This will lean the mix out and should start up easier with no problems,The idle issue is most likely just off.If your fiance still has the TORS on it then on top of the carbs he will see 2 dime size and screws and wires as soon as he takes his seat off.While running he can turn each dime size screw in or out to adjust the idle. If it has a TORS elimator kit on it then he won't have all the junk on top of the carbs and it will be just a cable and round cap screwed directly on top of the carbs and the idle screws will be on the side of each carb (brass color screws with nuts to tighten) same thing...in or out to adjust the idle where needed.Hope this helps.

-Steve

Jun 08, 2009 | 1986 Yamaha RD 350

1 Answer

2006 f350 wont start if warm


It is Vapor Locking at the Pump. The O rings are Swelling too much and will not allow the fuel to leave the Pump or enter the Injectors.
Ford knows of this Problem. Call a Local Mechanic He will have to Fix the Problem

May 12, 2009 | 2006 Ford F 350 Super Duty

Not finding what you are looking for?
1986 Yamaha RD 350 Logo

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...