Question about 1997 Honda VT 1100 C2 Shadow Sabre

1 Answer

Nutural light wire to motor . if i wiggle it it will start if it moves the green light will go off and then you wiggle it again to sa art it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Honda Master
  • 1,508 Answers

You will need a new neutral sender switch

Posted on May 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Chevy Silverado 3500 won't start I get clicking and the lights work, battery is new and has full charge and I replaced the starter and it ran great for about a month. Now I cannot get it to st


Believe it or not the starter may have gone bad again. Check all wires to the starter motor too. One broken or loose wire there will do it too. With the headlights on, attempt starting, if lights don't dim even a little then the load on the battery is not increasing indicating an open circuit to the starter OR inside the starter.

Oct 12, 2014 | 2004 Chevrolet Silverado 3500

1 Answer

When putting into reverse it has to be in the


This sounds a lot like the bush's in the gear change linkages are either worn out or gone. I have seen this a few times. Ask someone to check to see if the linkage moves when you move it only one place. Do this with the motor off and the hand brake on. Select nutural. Ask a friend to see if the gear selector moves when you select "D" drive. If there is little to no movement, time to start looking at linkage bush's

Sep 16, 2014 | Cars & Trucks

1 Answer

230 volt waterway spa pump model#sd-20-2n22cd electal scamatic


check voltage if 220 between two hots its 220 if only 120 low voltage if 220 ok then 1st hot to L1 then 2nd hot to L2 then green to ground or case if white you might have 120 volt then see side of case of motor for low voltage wiring

Apr 20, 2013 | Waterway Pool & Spa

1 Answer

Hello there,mate has a MX6 1993 auto what happens is intermitted driving along and the motor stops(kills) not out of fuel...you stop push the auto back into park and the car will start so away you go...


No one checks wires. Start the engine and start wiggling the wiring harness at different points. If it dies on you then you have found the general area to look. then you will have to go to wiggling one wire at a time. Time consuming at best, but not hard. Just a note, wires tend to start breaking right at the back of the plug

May 19, 2011 | 1993 Mazda MX-6

1 Answer

I have a 1996 Yamaha 400 Kodiak.Will not start with electric start.Nutural light and reverse light will only light after pull start with lights on,have replaced battery.


you have a switch going bad or a wire grounding out to one of the switches
either the neutral safety switch or the reverse light switch

Jan 19, 2010 | 2000 Yamaha WR 400 F

1 Answer

02 grand cherokee heater turns off when on


The is a 4 wire connector under the right side of dash to the blower motor resistor. Most likely what is happening is that the connector is loosing contact due to high resistance between the resistor and the connector pins. The connector has 4 wires, a black with tan tracer, a tan, light green and light blue. If you can get it to act up again, have someone wiggle the connector and see if the fan starts up again. If it start working you can either replace the resistor or you may be able to get by just slightly bending the metal tabs on the resistor.

Mar 27, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Hooking up generator switch panel


On a residence, the ground bar and the nutural bar may be hooked togethervia a ground screw on the case.    In that case it matters now which side you use for the nutural and which for the grounds. Just make sure to keep all of the whites on the white side and the greens on the green side.

Jan 11, 2009 | Cutler Hammer 200A 2POLE CIRCUIT BREAKER

1 Answer

Ceiling Fan


Green is always equiptment ground. It goes to the green wire ,if you have one in the electric outlet box,or mounted to the box itself itf you have not the green in the box.
Green always  to green White to white. Nutural wire. Orange to black if their is no black in the box. Orange =Black
I am also thinking that you blue will is also the positive for the fan. I woudl hook it to your orange also .  .

Jan 05, 2009 | Hampton Bay 24002 Ceiling Fan

3 Answers

Blower doesn't blow at all, but i feel heat on 1997 ford escort


check the wire connector located under the dash on the passenger side. a poor design, it can get kicked by a passengers foot. my blower got fixed by just wiggling it a few times!

Dec 12, 2008 | 1997 Ford Escort

Not finding what you are looking for?
1997 Honda VT 1100 C2 Shadow Sabre Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...