Question about 2007 Ducati 1098

1 Answer

Is it the red and black wire under the front of the fairing above the guard the one to put a trickel charger on or is it somewhere else

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,100 Answers

Did you buy the bike new or used? Ducati didn't put wires there or anyplace for a battery tender. They want you to buy a new battery. The previous owner may have. You will have to take off the left side panel, hook up your own cables to the battery and run them to a spot recommended by the tender maker. I have a list here of good ones and bad ones. Battery minder by VTC electronics, Or VDC, I can't quite make out the print. These are supposed to be the best, Deltrans are no good and yuasa's burn out in one year, Check it out.

Posted on May 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fog light red wire broke off


you can also use shrinkable wire butt connectors but I would go to either autozone or advance or somewhere even wal-mart and get a 2 wire polarized connector for a few bucks and cut all the wires and put the new connector on..use black tape to cover the bare wires for now..after all is just a light..

Dec 08, 2013 | 1997 Oldsmobile Eighty Eight

1 Answer

Spoolcase assembly


Do I understand right, you unscrewed two screws on the bobbin case holder and lifted it out? Underneath is a black plastic ring (inner guard ring) which sits inside the lower guard metal outer. I guess you undid the bobbincase to clear under it, I have seen machines with a lump of lint under turned into felt from being left so long. While its out, clean the underside and under the inner guard ring with your little brush, chech the bobbin case holder side too, there is a little groove on the side and sometimes tiny bits of thread will be caught in it. The trick is to turn the flywheel until the lower guard cutout open bit is facing 6 on a clock dial, ie closest to you. Now look at the inner guard ring, it has a flat edge cut off, turn it so the cut out faces about 7 on the clock and centred in the outer guard. Now you need to insert the bobbin case, it has a piece with two "beaks" on it, this is the front and these beaks need to sit between two metal parts in front of the outer ring which holds the bobbin case firmly. Put the front part in place and the whole case will fit in perfectly, just give it a little wiggle if it doesnt quite line up. Tighten the two shinny silver screws to fasten in place. There is a little black screw too but dont touch this, its a fine tension adjustment. Hope this assists you, if not post again andI will try to find a photo of the assembly.

May 20, 2013 | Elna Heirloom Edition 6005

1 Answer

I need to know how to wire the batteries together on my shoprider jimmie chair so they will charge


If the charger is 24 volts and you have 2 12 volt batteries they have to equal 24 volts , so wire the batteries terminals red to black and connect the charger to the other terminals red to red and black to black.

Feb 10, 2012 | Shoprider Jimmie Power Wheelchair

1 Answer

I have a blue jet 3 ultra n i just put 2 new batterys on it and all it will do is flash a red light in the top left corner of the battery light on the joy stick and the horn works but will not move what...


Check your battery wiring on the Jet the wires from the circuit breaker need to connect the positive of the front battery to the negative of the rear battery and the other wires connected to the positive of the rear battery and negative of the front battery putting the batteries in series to generate 24+ volts. If you have a voltmeter before you check the wiring set it to 200 volts dc and plug the leads into the 2 outter holes of the charger port located under the front of the joystick. If your batteries are wired correctly you should be reading 27+ volts without the charger plugged in and your batteries fully charged. If you are only reading 12 volts then the wiring is wrong and needs to be fixed. Leaving the voltmeter in the charger port plug in your charger and you should be reading 27 -30+ volts at the charger port anything less than 24 volts indicates your charger is not charging Hope this helps

May 22, 2011 | Jet 3 Ultra Power Chair

1 Answer

I have a fairly old panasonic car stereo/cd changer. i just need the wiring diagram for it. what color equals what? i typed in the model number but nothing turns up. . . i had to replace the old system,...


Here is the Colors of the Cars factory harness

Constant 12V+ Red Switched 12V+ Red/White Ground Black Illumination n/a Dimmer Orange/White Antenna Trigger Yellow Antenna Right Front Front Speakers 3 1/2" Dash Left Front (+) Green Left Front (-) Green/Yellow Right Front (+) Purple Right Front (-) Purple/Yellow Rear Speakers 6" x 9" Rear Deck Left Rear (+) Brown Left Rear (-) Brown/Yellow Right Rear (+) Blue/Red Right Rear (-) Blue/White


And Here is the Chart for the radios wiring

Red 12V+ Switched power
Grey Right front speaker +
Grey with black stripe right front-
White left front +
white with black stripe l/f -
Purple R/R +
Purple with black stripe R/R -
Green l/r +
green with stripe l/r -
Black ground
orange illumination
yellow constant power

Apr 07, 2010 | Car Audio & Video

1 Answer

I have an elite robo swing r900 gate opener. gate door's are not closing, battery keeps beeping and it shows low battery


first check you battery and make sure it is putting out 12v dc then if you have a solar power system check the red and black wire comming from the panel and make sure it is putting out 24volts. if you panel is not putting out the volts it caused your battery to die so replace your panel and battery and all should work fine. if your using a trickel charger do the same check power its putting out and make sure its correct and also check the 120v ac comming in to the charger. Follow the steps it deffinatly sounds like a power issue.

Nov 09, 2009 | Elite Sl 3000 Ul Sliding Gate Operator

2 Answers

I need help I don't know what color wires go to what wires on my sterio deck


I have a radio wire connector on a 1994 Toyota Camary and the color don' match your list, here is my list.
2 reds, one silver dot, one double silver dot.
2 blacks, same as above,
2 greens, same as above.
2 whites, same as above.
2 browns, same as above,
1 white w/green stripe, two silver dots
1 black w/red stripe, one silver dot.
1 yellow, two silver dots.
1 blue, two silver dots.
the numbers on the connector are A02 16 14 11264 9 8.
I'm clueless which wire are which.

Oct 30, 2009 | 1994 Toyota Camry

1 Answer

Wiring To an 08 Ultra Classic


If you are mounting the unit to the bars or fairing, I would recommend using a power lead which is available in the fairing, rather than the AUX accessory switch.  The AUX switch sends power to a connector under the seat, in front of the battery.  You would need to run new wires up under the fuel tank, along the neck and into the fairing to connector your Zumo to the AUX.  Instead, there is a 12+ V switched ignition power lead which is not used on U.S. touring bikes and would be perfect for connecting your Zumo.  Pull the fairing off the bike (7 screws, TORX T-27) and look at the headlight harness, which is 3 wires, black, white, yellow.  Attached to this harness will be 2 wires, a black and an orange w/ white stripe.  The orange will have a red silicone cap over it to prevent it from shorting out in the fairing.  Cut the zip-ties which connect these 2 wires to the headlight harness and then hook it up to your Zumo, black is negative, Orange positive. 

Apr 21, 2009 | GPS

4 Answers

I need to charge my battery and I'm not sure what to do. I have purchased a small charger.


all you have to do is clamp the red clamp to the red wire battery post and the black to black. Then plug in the charger.

Apr 15, 2009 | 1995 Suzuki VS 800 Intruder

1 Answer

Starter wiring


That wire probably goes to the transmission inter-lock. That prevents the car from starting if in any position other than Park.

Jun 20, 2008 | 1995 Honda Civic del sol

Not finding what you are looking for?
2007 Ducati 1098 Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ducati Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

bobkoure

Level 1 Expert

36 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Are you a Ducati Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...