Question about 1997 Suzuki GSF 600 N Bandit

1 Answer

Gsf 600 bandit starts and idles but cuts out when pulling away

My gsf600 bandit starts and have been riding with no problems. i bought the bike about 3 weeks ago but now when i pull away in 1st gear it cuts out any help would be appreciated thanks.
Please bear in mind i am not mechanically minded be gentle please : )

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 126 Answers

This could be ignition related or a fuel problem or even a combination. If you not mechanically minded you are probably better off taking it to a shop. If you would like to try some things first I would recommend changing the fuel filter and the spark plugs(make sure to gap them properly) if that doesn't work. After that it gets more complicated and the shop is your best best.

Posted on May 03, 2010

Testimonial: "Thanks for the advice i have also been told it could be blocked carbs so to the garage it will go, thanks again."

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What wires from the wiring harness on a 98 Suzuki Bandit gsx 600 need to be connected to make motor work in a mini sand rail. Wire colors would be of a great help. I just bought this project off...


Hi, Robert for this scenario you will need the wiring diagram your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
1996 Suzuki GSF600 bandit wiring diagram pdf
Yamaha Motorcycle Wiring Diagrams
Suzuki GSF600S Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gs-owners-manuals

Feb 28, 2015 | 1998 Suzuki GSF 600 N Bandit

1 Answer

Gsf 600 cuts out when riding ignition dies then comes back on .when stationary nuetral light flickers,try to turn on makes a connection sound ie electrical noise but does not fire up .have enough fuel and...


sounds like an ignition problem or a connection problem my freind .first disconnect the key to wire plug they sell electrical connecter cleaner fairly cheap being a 2000 the plug might be gummed up.if not that pull your ignition off most bike shops will tell you if its bad last but not least check for loose n corrooded wires around positive an negative starter n ignition. good luck hope i was of help.be sure to disconect yer battery before all.

Apr 03, 2011 | 2000 Suzuki GSF 600 N Bandit

1 Answer

Fuel is leaking from the carb into the cylinder and airbox when bike left overnight. Changed the jets but problem still there


You should adopt the habit of turning the fuel tap off when not riding, this will isolate the gravity pressure from the fuel in the tank.

The jets control fuel flow when engine is running,

I would think your float needle and seat is worn in one or more carby's. try a spray through of carby cleaner by turning fuel tap off and taking fuel drain screws out of all 4 carby's, disconnect fuel hose from fuel tap, allowing fuel to drain from lines and carby's. Spray carby cleaner into fuel hose and allow to flow out through all four carby's, allow to drain fully and dry out. Replace drains and fuel line and let fuel flow to carby's and see if a spray clean has done the job.

If not, inspect each floatbowl needle and seat. The link below gives exploded views of the bike in sections, with part names to help you get to them. Cheers.

http://www.cmsnl.com/suzuki-gsf600-s-bandit-2000-2003-usa_model16067/partslist/

Jul 31, 2010 | 2002 Suzuki GSF 600 S Bandit

1 Answer

Whats the difference between the gsf600 and gsf1200 front brake discs will 1200 front brake discs fit a 600


think the disc them selfs are bigger on the 1200 than the 600...also they have diffrant brake calipers as well on each bike...so i dont think 1200 disc & calipers will fit the 600

Mar 04, 2010 | 1998 Suzuki GSF 1200 Bandit S

1 Answer

Suzki bandit 600


Your battery is dead, the extra draw when trying to start is pulling the wattage so low that your clock is resetting. It will run fine until the battery goes dry and then lightbulbs will all go out and you'll blow your rectifier/regulator. Replace or refill and charg your battery and you'll be good to go.

May 29, 2009 | 2002 Suzuki GSF 600 N Bandit

1 Answer

Return to idle problems


This is a carb issue,just get the carb cleaned.



Please rate this a fixya

Feb 01, 2009 | 1998 Suzuki GSF 600 N Bandit

Not finding what you are looking for?
1997 Suzuki GSF 600 N Bandit Logo

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...