Question about 2007 TN'G Low Boy 150

1 Answer

My headlight keeps burning out on my znen tommy 150cc scooter every few days i have to put a new bulb in WTF?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 311 Answers

Hi,sounds like your voltage regulater has failed,it is supplying to much voltage to the bulb and causing it to burn out,if you dont have a voltmeter take the bike to a garage and check the voltage ,with the bike running at about 2500rpm,the meter shouldnt read more than about14.2-15.0v,if it does,that means it is faulty,hope this helps...cheers

Posted on May 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My headlight blew and now my TaoTao 50cc has no lights whatsoever what would cause that


Hi, Bill if your headlight is not working, only one beam works, keeps burning out, blinking, or is dim the first thing you need to check is the headlight bulb for damaged filaments then check your light circuit fuse, then check your head light bulb socket ground wire for a clean tight connection, that being said the usual suspects are:
1. Faulty ground or power supply wire to headlight bulb socket.
2. Worn down solder contacts or loose fit of the bulb base in the socket due to vibration.
3. Worn, chaffed, or broken wires in the light circuit.
4. Corroded, broken, or loose pins/sockets in wire connectors.
5. Faulty hi/lo beam switch.
6. Faulty ignition switch.
7. Fuse is good but no continuity on both sides.
8. Faulty wiring between battery positive and headlight bulb socket.
9. Weak charging alternator/generator.
10. Faulty voltage regulator/rectifier ground or overcharging.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
HEAD LIGHT BULBS BURNING OUT
Why is my Tao Tao scooter headlight shorting out
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
https://taotaopartsdirect.myshopify.com/collections/thunder-50
TaoTao ATM50 A1 Owner Manual

Apr 28, 2017 | Motorcycles

1 Answer

Where can I get a Znen scooter manual for a 2008 250cc scooter


Hi type in Google search. ::::: (PDF) Znen es150 manual in PDF.,..,,,.there r a few pages that might help ... Cheers

Nov 12, 2016 | Health & Beauty

2 Answers

Have a brand new jonway 50cc 15 miles blew bulb whats wrong


Occasionally bulbs will fail for no reason. Replace the bulb and try again. If it fails again, then you likely have a problem.

May 23, 2016 | Jonway Motorcycles

1 Answer

2008 150cc Znen scooter. What causes it to bog down at 55-60 mph?


Hi, Ty and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap too close or too wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in the fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, O2, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
Headlights melting Engine bogging down
Yahoo Groups
SportiqueScooters com Scooter Buyers Primer http://www.carlsalter.com/pdfs/Znen_ZN250T_D.pdf
Gy6 50cc 150cc Scooter Repair service Manual Download Manuals Technical

Mar 06, 2016 | Znen Motorcycles

1 Answer

Have a PRO F-Sports 4 Stroke 150cc Scooter. Headlights don't work. All other lights are ok.


Hi, Dan if your headlight is not working the first thing to check is the headlight bulb for damaged filaments then check your light circuit fuse, that being said the usual suspects are:
1. Faulty ground or power supply to headlight bulb socket.
2. Faulty hi/lo beam switch.
3. Faulty ignition switch.
4. Fuse is good but no continuity on both sides.
5. Faulty wiring between battery positive and headlight bulb socket.
Good luck and have nice a day.

Aug 10, 2015 | Motorcycles

1 Answer

Znen 150cc scooter vapor lock


If it starts and runs for a few minutes then dies and won't restart for while, check the fuel tank vent, most likely located in the fuel cap. If it runs fine with fuel cap off thats your problem, it's plugged, Frank

May 23, 2012 | 2010 Znen ZN 1256

1 Answer

Znen Scooter Headlight keeps burning out!!!! Ya i keep putting headlight bulbs in my scooter and every couple days the damn thing burns out! WTF?


sounds like you have too much voltage coming out from your battery, mabey a faulty regulator. The easiest way to test this, is to get a multi - meter, and check the volage output at the battery, with the engine running, at idle should read about 12.5 - 13 volts. Then rev the bike up, and seeif the reading changes, it should not go more than 13.8 or 14 volts max. If it does, then i say you have a faulty regulator/ rectifier.

May 03, 2010 | 2001 Yamaha SR 125

1 Answer

HEADLIGHT BULB KEEP BURNING OUT ON MY BENZ..2002 C CLASS


Try to put a relay on every bulb to prevent burning, and also check the bulb socket make sure it is not loose.

Jun 09, 2009 | 2001 Mercedes-Benz C-Class

Not finding what you are looking for?
2007 TN'G Low Boy 150 Logo

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top TN'G Experts

adam bikedoc

Level 3 Expert

661 Answers

Hampi Hemp
Hampi Hemp

Level 3 Expert

706 Answers

John White
John White

Level 2 Expert

117 Answers

Are you a TN'G Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...