Question about 2005 Qianjiang QJ100-4

1 Answer

Older 100cc moto 4 cranks but wont start has weak spark new carb kit

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

PUT A NEW COIL IN IT

Posted on May 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is low oil sensor 13-hp.briggs


check gap on coil the gap on the points and also make sure the magnets are free of rust, the capacitor could be weak also.

Jun 11, 2014 | Briggs & Stratton Ignition Kit 2-8 HP...

2 Answers

How to adjust mikuni carb on yamaha moto 4


idle screw on left or right. Airscrew should be near carb intake ,careful only brass, 1 1/2 turns out from full close will get you close.

Jun 02, 2014 | ATVs

1 Answer

Will not start turn over


make sure batt is charged to 12.6volts-if not then weak spark--it cud be old an worn too--or alternator needs service--chec connections for corrosion----inspect fuel delivery from tank to carb----may want to test compression-mite b weak

Feb 27, 2014 | Triumph Rocket III Motorcycles

1 Answer

It will turn over but wont crank


Not starting issues are usually spark or fuel problems. If you have gas getting to the carb then check your spark. First check all the wire connectors and plug wire to make sure everything is connected. If you find a loose connection fix it then try it. If not, then remove the spark plug but leave it attached to the plug wire set it on the cylinder head and turn the engine over. You should see a bright spark. If you have a really weak spark or none at all, then it may be your ignition coil or a related ignition part.

Jan 28, 2014 | kawasaki 2006 Bayou 250

1 Answer

My bajaj discover 100cc give jerk when I reach at the speed of 50 to 60kms on 4th and 5th gear. I had show to all mechanic but they didn't solve the problem. This jerk problem was observerd from day o


Hi, Anonymous and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition and leaking.
3. Spark plug gap too close or too wide.
4. Faulty ignition coil, module, and or sensor.
5. Battery nearly discharged.
6. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
7. Intake air leak.
8. Water, dirt, or rust in the fuel system, carburetor and/or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose, dirty, or corroded ignition module connector at crankcase.
13. Faulty MAP, CKP, O2, and/or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damaged intake or exhaust valve.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Despiece de la moto Bajaj auteco Platino 100 cc

Nov 21, 2013 | 2005 Bajaj Pulsar 150

3 Answers

MY SON HAS A TTR 125. IT WONT START. HAS NEW PLUG, NEW GAS, I JUST FINISHED REBUILD KIT ON CARB. ITS GETTING SPARK, ITS GETTING GAS IN SEDIMENT BOWL. IT WILL ACT LIKE IT WANTS TO START AFTER ABOUT 10...


A rebuild kit on a 2004? Why was that needed?
I would do a compression test to verify that the ring, and valves are working for you. Should be above 100 psi. (Throttle open while kicking it over) This may help get you started toward a fix.

Jun 09, 2010 | 2004 Yamaha TT-R 125 L

2 Answers

Honda lead 100cc scooter wont start atall.changed the spark plug and filter still no luck.doesnt seem to be getting petrol to the spark plug


maby you have touched somthing on the carb when you changed the air filter or maby spark plug is to big or maby faulty try new one or your old one

Apr 13, 2010 | 2007 Honda XL 125 V Varadero

2 Answers

My RAM 100cc quad bike wont start. iv checked the flow of fuel into the carb and it all seems okay and the spark plug is sparking. The electric start button doesnt work though and when i kick start it...


You need to check if there is any leaks from the carb to the motor. Make sure the carb is clean. An airleak could prevent the motor from starting as well as checking the carb itself ....the floats the jets things in that nature.

Feb 13, 2010 | 1989 Honda CBX 250

3 Answers

Partner K750 wont start


i have seen these saws split the diaphram in the carb, so get that carb out and take off the bottom 4 screws... also iv seen 1 with the igniter coil gone weak and only sparking the plug the odd time so make sure yu hav a good spark also...

Jun 06, 2009 | Husqvarna Saws

1 Answer

Spark plug fouling when cold starting


sounds like the carb wants cleaning and re-balancing

Jan 24, 2009 | 1996 Yamaha SZR 660

Not finding what you are looking for?
2005 Qianjiang QJ100-4 Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Qianjiang Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

GQ-ROD

Level 3 Expert

635 Answers

Steve Luck
Steve Luck

Level 3 Expert

817 Answers

Are you a Qianjiang Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...