Question about 2003 kawasaki ZX-12R

1 Answer

How do you get where the spark plugs are?

Took the tank cover off, raised the fuel tank, what next?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 164 Answers

You need to remove the tank completely once you have it of the plugs can be accesed use a tube spanner after removeing the plug leads

Posted on Apr 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 CAPRICE WITH LT1 WONT STAY RUNNING


check fuel regulator, fuel pressure, could be bad sending unit in fuel tank, change out fuel filter

Apr 30, 2012 | Chevrolet Caprice Cars & Trucks

2 Answers

I drive a 05 altima with about 59000 miles on it. When starting the car in the morning it starts perfect and drives good however if I drive somewhere and leave it sitting there for at least 10 mins it...


SOUND LIKE FUEL PUMP PROBLEMS.THE JUMPING YOU FEEL CALL SURGING.TRY REPLACING SPARK PLUGS AND WIRES. DONT REPLACE SPARK PLUGS IF YOU HAVE PLATINUM AND IRIDIUM TYPE THEY ARE 105000 MILE PLUGS.CLEAN FUEL INJECTORS SEE WHAT HAPPENS.

Dec 03, 2010 | 2005 Nissan Altima

1 Answer

I need a diagram to replace a fuel tank on a 1987 vw cabriolet


1987 Volkswagen Cabriolet 1.8L FI SOHC 4cyl

1985-89 Scirocco and Cabriolet
  1. Disconnect the negative battery cable and drain the fuel tank.
  2. Remove the rear right wheel housing cover.
  3. Disconnect the large breather hose from the filler neck.
  4. Pull the gravity valve down leaving the hoses connected.
  5. Unbolt the fuel pump bracket from the body and lower the pump.
  6. Remove the fuel tank screw.
  7. Disconnect the fuel pump hose and pull the blue hose from the return line.
  8. Disconnect the brake hoses from both sides of the rear axle and plug them.
  9. Disconnect the rear axle from both sides of the body and allow it to swing down and rest on the handbrake cable guides.
  10. Unhook the rear muffler support lugs.
  11. Disconnect the filler hose from the tank.
  12. Support the tank, remove the tank fasteners and lower the tank enough to disconnect the fuel gauge sending unit wires and breather hoses.
  13. Remove the fuel tank.

To install:
If installing a new or used tank, make note of where the old foam strips were installed, and install new foam strips on the replacement tank in the same locations.
  1. Raise and support tank. Connect the small breather hoses and fuel gauge sending unit wires. Install the tank fasteners.

When connecting the breather hoses, position the hose clips so that they do not make contact with the body.
  1. Connect the filler hose to the tank and connect the rear muffler support lugs.
  2. Raise the rear axle off the handbrake cable guides and install.
  3. Connect the brake hoses and bleed the brakes.
  4. Connect the return line and fuel pump hose.
  5. Install the fuel tank screw.
  6. Raise the fuel pump and attach the fuel pump bracket to the body.
  7. Put the gravity valve back into its original (raised) position.
  8. Connect the large breather hose to the filler neck.

When connecting the breather hose, position the hose clip so that it does not make contact with the body.
  1. Install the right rear wheel housing cover.
  2. Fill the tank and connect the negative battery cable.

40071b2.jpg

Fig. 1: Fuel tank assembly used on the Rabbit Pick-up. Other models are similar

Hope helps (remember to rate and comment this).

Sep 21, 2010 | Volkswagen Cabriolet Cars & Trucks

1 Answer

Have a Mac 3214, fuel lines were rotten, replaced lines spark plug and air filter. Started saw ran fine. Shut off saw, heard a girgling sound took off carb cover had fuel filling carb above throttle blade,...


The fuel metering needle in the lower carburetor chamber may have a bad rubber tip or the rubber diaphragm may be hard or cracked. McCullough fuel tanks vent through the cap (it should not have a gasket). Gravity plays no part in the carburetor fuel volume. Remove the spark plug (ignition off) and pull the engine through a few times without the choke on, but the throttle wide open to remove excess fuel in the crankcase (no smoking during this procedure). Make sure the plug is dry when you put it back. Hope this helps!

Apr 18, 2010 | McCulloch 10" Electric Pole / Chain Saw

1 Answer

How do i change my spark plugs on suzuki c50 motorcycle


No. 1 (FRONT) SPARK PLUG REMOVAL
• Remove the rear and front seats.
• Remove the fuel tank.
• Remove the right frame cover 1 (remove hooked part)
• Remove the spark plug cap
• Remove the spark plug with a spark plug wrench.
No. 2 (REAR) SPARK PLUG REMOVAL
• Remove the rear and front seats.
• Remove the fuel tank.
• Remove the spark plug cap.
• Remove the spark plug with a spark plug wrench
Hope this help you quest. Good enough?

Apr 18, 2010 | 2005 Suzuki Boulevard C50

2 Answers

Husqvarna chainsaw stops when using it


Check for spark after it quits. If none, the ignition module may be dying when hot. If ok, check the muffler for plugging. Use compressed air to remove sawdust from cylinder and head area. If everything looks good, note whether the spark plug is getting wet with fuel after trying to restart the saw. If dry, check the fuel lines for cracking or other deterioration. Make sure the fuel tank vent is clear of debris. (Loosen the fuel cap for a moment, then see if it will start.) Hopefully, one of these suggestions will hit on the problem!

Feb 19, 2010 | Husqvarna Chain Saw 20" Bar

1 Answer

Will turn over but won't start


bang on bottom of gas tank to unstick dry fuel pump motor,the gas is what keeps the fuel pump bearings lubed

Jan 29, 2010 | 2005 Dodge Grand Caravan

1 Answer

I have a 2001 Vulcan that has been sitting for a while. I have pulled the tank and will clean the rust out. The bike would fire but not start up. The fuel I took out was discolored with rust. It appears...


I don't recall needing to remove the valve covers. The spark plug wires go from the coil into a 1" diameter insulator tube / spark plug cap. The tube protects the wire from the engine heat. Remove the tube / cap then remove the plug. The stock plug is NGK CR7E. For the tank, after cleaning, get a liquid tank liner and rust will never be an issue again. Google “ kreem fuel tank liner “ or go to www.http://www.4secondsflat.com/Fuel_Tank_Sealer.html

FYI >
Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. In the event no price is shown on a particular part, the part is not in stock. www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx

Jun 07, 2009 | 2002 kawasaki VN 800 Vulcan Classic

2 Answers

Parts location in 1997Catera


rear of the engine, behind the right valve cover.

Mar 22, 2009 | 1997 Cadillac Catera

Not finding what you are looking for?
2003 kawasaki ZX-12R Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...