Question about 2003 Harley Davidson FLHR Road king

1 Answer

Oil coming out of one pipe and carb. Why? - 2003 Harley Davidson FLHR Road king

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 641 Answers

Sounds like maybe your gasket got worn out from the heat which is possible. I would turn off the pitcock to the fuel and pull off the tank to access the carburetor and pull that out then open up the top to see up close what's going on. Clean the carb casing and examine the seal around the lip.

Posted on Apr 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No oil getting to engine


easy fix did one yesterday, first off take off the side engine casing, the one where your drive belt is, underneath the front varietor you will see the 2 stroke oil pump, its only small but easily visible. It has a large tube going to it and a smaller one the large is the feed tube from the 2 stroke oil tank and the smaller one is the feed tube to the carb.
you have to prime this pump in order to get the oil to the carb. start by making sure you have pleanty of 2 stroke oil in the bottle, nec=xt on the oil pump in the centre of the 2 pipes is a pozi head bleed screw, undo the a few turns but not all the way out then take the lid off your 2 stroke oil tank and allow the oil to run freely from the tank to the pump until you see it go into pump with no air bubbles should only take a few mins, once this is archived, tighten the bleed screw back up, next you have to get the oil from the pump upto the carb, easiest way is to crank the engine over with the spark plug out this will pump the oil to the carb, make sure to have the throttle open as this allows the oil pump to open thus passing oil upto carb once you see oil up the little pipe to carb your all sorted.
i would place some petrol mixed with 2 stroke oil in the tank as your cranking a engine with no oil in it once it is primed up just fill with petrol and you will be fine.

Nov 15, 2012 | 2011 Piaggio NRG Power DD

1 Answer

I have a pulsar 150,now my carburetor leaks oil from waste pipe,my mechanic firstly shown rust in oil tank then he change the tank ,many times clean the carburetor and change the pin.but oil leakge not...


Hi,the way it works is.....petrol gose from tank into filler pipe into carb it fills the bowl at the bottom of carb float rises and shuts off the petrol by means of a inlet valve when float pushes it shut,
so if there is petrol coming out of the over flow pipe from the carb bowl it is iver the valve is worn(can be replaced)or the float is not at the right level(to high) or float has a hole so sinks(get a small container put petrol in it and put float in if it floats its ok)the other thing is the gasket that gose between the bowl and and top part of bowl make shore its not broken,
hope this helped all the best.

Jun 06, 2012 | 2011 Bajaj Pulsar 150

1 Answer

I have a CS 440 chainsaw. Accidentally placed chain oil in the gas/oil chamber. Cleaned it out quickly but now the chainsaw will not run. What else can I do?


The filter, fuel hose, and possibly the carb is now full of chain oil, pull the fuel pipe off the carb, with the fuel filler cap off blow through the pipe to clear any oiltrapped. now replce the filter on the end of the pipe, go through the start procedure, if it still will not start, remove the air filter and drizzel a small amount of fresh fuel oil mix straight into the filter elbow, this should start the engine, if it stops again repeat the process until it clears itself.

Sep 19, 2011 | Echo Garden

2 Answers

Not getting gas in the carb. changed pump. poured a littlr gas in the carb good compression but dies when gas runs out


get a oil can the thumb operated type and squirt some oil down the petrol pipe and make sure pipe is upwards so the oil runs into the pump then leave for a while to wet the valves in the pump then crank engine to make sure petrol comes up or just refit the pipe and pour some petrol down the carb and watch it go

Aug 16, 2011 | 1986 Dodge Ram 50

1 Answer

Bout a bike 2 day been out for a hr and noticed lots oil near the carb n airbox n its seems to be coming frm a pipe which is conected to the top of engine


check your oil level maybe it is more than full if it is good, check your muffler if there is white smoke coming out. if there white smoke coming from your muffler you have a problem in your piston rings, need to be change. thanks...

Apr 27, 2011 | KTM 250 EXC-F Motorcycles

1 Answer

2001 volusia 805 lots of oil in airfilter housing it looks like it is coming in from carb area. Tons of smoke out of tail pipes


check your oil level to see if your engine is over filled.
Also smell the oil to see if you have gas in the oil cause buy a bad fuel petcock allowing fuel to seep into the engine if the bike was stored for some time.

May 19, 2010 | 2001 Suzuki VL 800 Volusia

1 Answer

Black smoke front engine on motorbike


check valve cover is it leaking oil. clean up the engine real good....i use chemtool B-12 carb cleaner.. wear gloves and don't breathe the fumes and if it gets on the exhaust, you"ll see smoke come off the pipes, so let it dry up before riding and wipe the exhaust pipes real good...now ride the bike and see if you see any smoke...when you do, pull over and take a look to see where its coming from...it could also be coming from a leaking exhaust pipe gasket.

Oct 02, 2009 | 2002 Triumph TT 600

3 Answers

Gas coming out of the tailpipe when i try to start my motorcycle


Is your choke stuck open? And maybe the slides in the carb are stuck in the up position.

Sep 29, 2009 | 1995 kawasaki VN 800 A Vulcan

1 Answer

OIL IS COMING THROUGH FRON PIPE AND SMALL LEAK FROM SAME


Raw fuel picking up and mixing with oil. Chk carb float levels and fuel tank petcock. Make sure petcock is not on PRI. That is the prime position and will let your fuel run free. been there, done that.. Good Luck- Ned -

Jul 11, 2009 | 2002 Yamaha Road Star

2 Answers

My scooter is blowing alot of white smoke and bogging down.


replace the spark plug 2cycle engines are hard on plugs also sounds like it needs a carb cleaning black smoke means carb is fooding

Apr 01, 2009 | 2005 TN'G Verona 150

Not finding what you are looking for?
2003 Harley Davidson FLHR Road king Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...