Question about 2001 Victory V 92 C Deluxe

1 Answer

What is the part that is mounted on the bottom of the frame just under the sylinoid. it is sits in the front of the bike.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

Voltage regulator, that is if your speaking of the square block with fins

Posted on Jul 02, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Keep breaking bolts on my front motor mount 95 electra glide. Replaced the mount withing 1000 miles

it could be the problem and it could be that you need a harder tensile bolt ,if you undo all the bolts on the engine mounts it could be that the motor is not sitting right in the frame .if you keep getting the problem you might need to get the frame checked cheers pete

Mar 06, 2014 | Harley Davidson FLHTCUI Electra Glide...

1 Answer

Where is the serial number on a davinci chili pepper

On almost all bikes the serial number is either on the outside of the left rear dropout (where the axle sits) or under the bottom bracket (where the crank axle goes through the frame).

Mar 25, 2013 | Devinci Chili Pepper

1 Answer

Wheres the drain plug on 2011 fat boy

theres 3 which one? Primary left side of bike bottom of inner primary just below derby over, transmission under bike between rear shocks , oil is right side bottom in frame just in front of pivot shafts . 5/8th plug

Apr 14, 2012 | 2011 Harley Davidson FLSTFB Fat Boy Lo

1 Answer

Trying to install Sunlite HD tourer rear carrier #45772. on a Rand 18 speed. There are no holes for front brackets in frame. Do you just drill the holes?

Never drill holes in a bike frame unless you have a death wish. "Rand 18-speed" doesn't tell us much. Most cheapo bike frames have a 'brake bridge' with a hole on the center for mounting accessories like fenders. Many racks can mount with a single rather than double front supports.. Lacking that, call a bike shop or web search for "bicycle seatstay rack clamps" to adapt the rack to attach to the seat stays.

Sunlite also makes a seatpost rack mount which looks like a more elegant way to solve the problem.

Sep 13, 2011 | Cycling

1 Answer

I dont have a owners manuel for my stratoliner not sure where the oil plug is it is a 2006 1900

sitting on the bike it's on the left side front bottom of the motor between the frame rails coming out the side of the bottom towards the left. It comes out the left side front bottom inside the frame rail. An open end or closed end wrench needs to be used as theirs not enough room for a scocket and handle. won't fit. It's either 19 or 17 MM.

Jul 11, 2011 | 2006 Yamaha Stratoliner

2 Answers

When i "goose" the gas

engine or trans mount prob. has 3

Jan 06, 2011 | 2000 Pontiac Grand Prix

1 Answer

Trying to replace alternator on a 99 Chrysler 300M but can't get the top bolt out due there's not enough room.Do I have lower or raise the engine

yes you do have to lower the engine so that the bolt will slide out threw the bottom of the inner fender frame. it is a pain to do this. take out the bottom motor mount alont with the top mounts on the motor but make sure u put a jack stand under the mount that sits under the motor so the motor does not fall

Sep 27, 2010 | 1999 Chrysler 300M

1 Answer

Need to know where clutch cable runs from tranny to fairring. need diagram

I don't think I've ever seen a diagram of the routing of the clutch cable. The cable comes from the left handlebar to the frame. It runs down the left side of the frame, between the front engine mount on the frame and the engine. Along the lower frame tube on the right side of the bike and up to the bottom of the chrome clutch release housing on the right side of the transmission. I hope this helps. Good luck

Apr 12, 2010 | 2004 Harley Davidson FLHTCUI Electra Glide...

1 Answer

There is a bushing near the front of the frame where the engine sits and it's melting. Is this a quick fix?

If you're talking about the rubber front engine mount, yes, it is easily replaced. You'll need a way to hold the bike up straight. Take the bolts out of the front engine mount and useing a small scissors jack and piece of wood (between the jack and the engine case) carefully raise the engine until you can get the mount off the frame. Put the new mount on. lower the engine, and tighten everything up.

Mar 07, 2010 | 1993 Harley Davidson FXR Super Glide

1 Answer

Cabinet and back of washer are not fitting after replacing lid switch

The bottom front of the cabinet fits under the front of the frame, and the sides sit on top the frame. There is a notch towards the rear of the sides (on the bottom) for alignment to the frame.If they are aligned, the back will match right up.

Jan 16, 2010 | Whirlpool Ultimate Care II LSQ9549L Top...

Not finding what you are looking for?
2001 Victory V 92 C Deluxe Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Victory Experts


Level 3 Expert

79865 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4903 Answers

Joseph Hoffmann

Level 3 Expert

1746 Answers

Are you a Victory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides