Question about 2002 kawasaki W 650

1 Answer

Belt light stays on 650 praire - 2002 kawasaki W 650

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 653 Answers

Have you checked the belt light sensor and its connections? Is the wiring properly grounded and are in good conditions? Good enough to start searching?

Posted on Apr 26, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is the proper way to in stall this belt

Jermaun, ensure you have proper size belt, and if it is a directional belt, it has to be installed with arrows pointing in the direction of engine pulley rotation. Watch the links below and do not pinch your fingers. Good Luck.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Changeing belt POLARIS ATV
Polaris Belt Change
How to replace CVT belt on Can Am Outlander

May 14, 2016 | Cars & Trucks

1 Answer

I have 03 kawasaki praire 650 v-twin its backfiring through front carb and wont run whats wrong

Backfiring through a carb is indicative of over advanced ignition. The spark is firing the fuel too early and exploding through the carburettor, instead of firing the piston over Top Dead Centre (TDC).

Another possibility is a damaged valve, do a compression test and get the timing checked.

Jan 02, 2016 | kawasaki Motorcycles

1 Answer

How to reset belt light

Your selt belt light is on when its buckled and no one else is in the car correct? That could be a body code and dealers or someone with a tech 2 would need to scan and clear that. You could have a bad switch on your seat belt buckle.

Nov 08, 2015 | Arctic Cat 2005 650 H1 4x4 Automatic

1 Answer

I installed a new battery in my Kawasaki prairie 650 and know the belt check indicator light is blinking

you need to reset your belt sensor if it reappers then you need a new belt or the sensor is bad

Jul 02, 2014 | kawasaki ATVs

1 Answer

I have a 2002 650 praire after it gets warmed up it starts missing out and the digital gauges go out

sounds like there is a wire that has been exposed and shorting out . as electricity flows through wires they heat up. as temp goes up the insulation around the wire gets soft so if wire gets pulled on or tugged on and there is a sharp metal edge it can cut through insulation and cause a short making certain items turn off.(id say if that's the problem it most likely to be around front of gas tank area. even the slightest indication of a wire that has had the insulation pinched or rubbed off take some electrical tape and apply around compromised area

Jul 15, 2013 | 2003 kawasaki KLR 650

1 Answer

Belt light came on

It can be one of a few things, if the units power is limited now since the belt light came on that its in "belt failure mode" if the light is just on its warning you that its been 100 hours and that your belt need to be checked for wear and servicing. You should have a qualified mechanic look at the belt and then they can reset the belt hour meter.

May 03, 2010 | 2001 kawasaki ZX-6R Ninja

1 Answer

Belt slipping on my 97 400 kawasaki praire

if you talking about the clutch belt then you need to put a new one on.

Sep 25, 2009 | 1997 kawasaki ZXR 400

1 Answer

I was wondering what was the range for the radioshack TRC-447 cb radio with a good cb antenna

Antenna :
-should be tuned, have good coax with no pinches, whip is centered over highest flat metal surface, no metal beside adjacent to whip, power is wired to battery direct, not to ignition or cigg lighter. whip is wiped clean of corrosion, whip is up, longer is better.
Praire City car-to-car: 15-20 km's
Praire Rural car-to-car: four-thirds over the horizon. Probably 60 km's.
Alot further over water.
Less within trees and mountains/valleys.
Google "Ham radio" & "ducting" "inversion" "skip" "sun-spots"
these refer to a condition where a radio signal getting stuck between the upper and lower atmospheres and travel intact for 1000's of km's (canada to mexico for example)

Sep 06, 2009 | Radio Shack TRC-447 CB Radio

1 Answer


Are you able to state if that belt is located in "Primary Drive Scot ( I own Rare 1975 W3A-RS & they had Duplex Chain & in 33 Years of hard riding, that chain "in sae 20 oil is still capable!!---Have we gone forward really with designs one must ask?--My W3A-RS can reach 180 KPH, but it has "Hung Together over lot of years, near bullet proof & up to 80 MPG how good is that/
Cheers, Stay Upright",-Des.

Nov 27, 2008 | 2003 kawasaki W 650

2 Answers

Subzero 650 light won't stay on when door shut

super...sounds like the switch you're pushing is damaged. test it.

Dec 15, 2007 | Sub-Zero 650 / O Bottom Freezer...

Not finding what you are looking for?
2002 kawasaki W 650 Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4525 Answers


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides