Question about 2005 Yamaha V Star 1100 Classic

1 Answer

When i start the bike and warm it up everything is cool, then i put it in gear and it quits running

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Yamaha Master
  • 1,508 Answers

There are safety switches on the clutch and sidestand, so you cant ride off with the stand down, one of those may be faulty,unplugged or have a wire broken

Posted on Apr 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I till over my bike in some water. It did get some water in the engine what do?


DO not turn the engine over. Drain and replace all fluids, including the fuel. Replace air filter(s). Open almost everything and drain water. You can use air to help. Unplug all multi-plugs and completely dry with blown air.
Pull plugs and turn engine over. This will expel excess fluid. Put plugs back in. Start the unit. Run until quite warm, but do not ride it hard. Work out any misfiring.
Drain and replace all fluids, while still warm. Then run the unit again for longer than 20 minutes after fully warm.
Make note not to ride in water again.
Doc

Apr 28, 2013 | Motorcycles

1 Answer

I have a 1988 Yamaha virago 750 my problem is that the front cylinder does not fire up after a while not always but often if you start bike it runs fine for 10 minutes or so then looses power because the...


Next time you get it warmed up, check the compression on the front cylinder when it quits. Be careful of course since it will be hot. It is possible that you are losing compression when everything heats up and expands, but it comes back when the bike cools.

Jul 16, 2010 | 1988 Yamaha XV 535 Virago DX

1 Answer

Quits running after it starts to warm up under 1 mile


Try your ignition coil. That year model chevy has a dry running coil and it does not go out all at once. It will spark and run while cool but just as soon as the everything starts to heat up the resistance in the coil begins to build and it quits firing. After letting the vehicle set a little while and cool off it will fire off and run just fine untill it starts to heat up again.

Jul 20, 2009 | 1994 Chevrolet Suburban

1 Answer

Bike will start but quits as soonas I put it in gear


Starts and quits? No assuning - Gas? Spark?, Air?Choke Open? Will it eun with partial choke? Fuel filter restriction causes slow loss of power or sensation of running out of fuel. Electrical is go or no go, and quits suddenly like the key was turned off.. So I don't think its electrical. No assuming. double ck all and bypas fuel filter for testing.. Good luck. Double ck fuel valve.

Jul 01, 2009 | 2006 Daelim Daystar

2 Answers

No spark after warming


it could be your coil. if it is shorting out internally

May 08, 2009 | 1989 Mazda B-Series

1 Answer

Clutch slipping while cold, when warm/hot, it operates great.


I have a 2000 Vulcan Nomad FI & had a very similar problem. In fact, it's a very common problem with these bikes. I fixed it by replacing the Clutch Spring. (As Described here: http://www.gadgetjq.com/clutch_spring_replacement.htm

It cost me $40 and 3 hours of time with an impact wrench.

Jan 23, 2009 | 2004 kawasaki VN 1500 Vulcan Classic

2 Answers

99 vstar 1100 quits when put in gear


couple of things to look for.

1. when you're putting it in gear, is the kick stand up or down. if down, most modern day bikes have a kick stand safety switch which will not allow you to put the bike in gear with the side stand down. this little relay may have failed. its usually located near the kick stand.

2. clutch disks may be stuck together. it happens on my old bikes from sitting too long (over a winter). when i pop it into first gear after i start it w/ clutch lever pulled, it will buck forward and die. i have to repeat a few times to get them unstuck.

good luck

Jan 21, 2009 | 1999 Yamaha V Star Custom

1 Answer

My vn88 1500. when at colder temps, barely moves then when warmer


i believe you have a fuel starvation problem or either the plugs are fouling out when cool then at warmer temps the oil is burning off. pull your plugs and check for corrosion

Jan 21, 2009 | 2004 kawasaki VN 1600 Mean Streak

Not finding what you are looking for?
2005 Yamaha V Star 1100 Classic Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...