Question about 2008 Suzuki Boulevard

1 Answer

Changing brake pad

Please let me know how to change brake pads on my boulevard c50.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Ok on the front calipers youll have a slot on the middle back with a flat head screwdriver pry the caliper towards the outside of the rotor.( cheap way to compress caliper) or buy caliper compressor take the two bolts outta the caliper on the sides remove pads and compress caliper piston with compressor for a walk through email. customsouth676@yahoo.com

Posted on Apr 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change the spark plug wires on a 05 Suzuki boulevard c50


Search Results

    05 Boulevard Tune Up Spark Plugs and Air Filter Install ...

    ? 7:01
    www.youtube.com/watch?v=CEMsA6fWCNM
    Jun 17, 2009 - Uploaded by Rick Mammana http://www.shopatnite.com 05 Boulevard Spark Plugs and Air Filter Install 2005 test ride tune up. ... 2005 Suzuki Boulevard c50, no more engine noise! ... How To Change / Remove Rear Tire On A Suzuki Intruder VL1500 and ... Suzuki Boulevard C90 -Wiring Installation (Mod 3) - Duration: 20:57. by Nate ...

Aug 30, 2015 | Suzuki Motorcycles

1 Answer

Removal of a front tire on a boulevard c50


your going to need a motorcycle lift or another way to get the front wheel off the ground and hold the bike safely. then remove the capiler from the front forks. once that is done. remove the cap to axle bolt and some have a second hold down bolt. my vl1500 has two bolts. 1 for the axle and a second to hold it in place. when removing the axle becareful to remember the location of the inserts for spacers. they can only go one way or the tire will bind up. might be a good idea to label the spacers with a maker and use an arrow to know which way it was pointing to help when putting it back together. and when you get the caliper off I use a screw driver to move the pads apart to make it easy to pull the caliper out of the way. when its back together. pump the brake handle a couple times to build the pressure up and seat the brake pads again. if not you wont have brakes when you try to stop.

Aug 16, 2014 | 2005 Suzuki Boulevard C50

1 Answer

Front brakes aren't releasing properly. How can I fix this problem? Is it a matter of bleeding the brakes?


Lets start with some simple things since you just put on new pads, I assume the brakes worked properly prior.
First, what kind of pads to you install? Some abrasive pads will make a grinding noise till they wear in. You can help this by filing a small beveled edge all the way around the pad surface.
Second, did you adjust the brake fluid level in the master cylinder after installing the new pads? After pushing the caliper piston in to install the new pads there may be too much fluid in the resevoir now causing a constant pressure in the lines. Place a towel around the master cylinder and remove the top. If fluid runs over the top you may have found your problem. Use a baster or syringe to **** out any excess fluid.

Oct 22, 2012 | 2011 Suzuki Boulevard M109R

1 Answer

I was changing the front disc brake pads on my 2008 Suzuki Boulevard S50. I took the two bolts out that hold the calipers together which caused the fluid to leak out and a small rubber gasket fell out ....


You will need to buy a new rubber gasket kit for caliper from suzuki shop
It is not usual to pull caliper apart for pad replacement, normally unbolt caliper off fork leg and lift of the disk

Jul 08, 2011 | 2008 Suzuki Boulevard

1 Answer

Should I open up the whole rear brake system to change the pads?


NO remove the caliper, remove the pad pin fit a screw driver in to the pads where the disk would sit and lever the piston back in...

Jun 29, 2010 | 2005 Suzuki Boulevard S83

1 Answer

My TPG scooter stops all of a sudden like I have braked


Two things you might need to check...your..belt or your brake pads condition.when it hots it expands and clamps, might need replacement.

May 26, 2010 | 2005 Suzuki Boulevard C50

2 Answers

Changing front brake pads 2006 c90t


If its the same as a c50 05 then there are two bolts that have to be removed. the brake unit is then pulled back in the direction of the wheel.
When it is clear the two pads can be slid out. The pistons can be pushed back by hand.
When the brake unit bolts were removed there might be a templet under the bolts, make wsure and replace it when replacing the bolts.when putting the brake unit back togeather again The pads are secured by a very small metal pin.This pin can be found holding one end of the pads in. A very small coiter pin is inserted after the pin has been put through the end of the pads. There is a very small hole in this metal pin.

Oct 02, 2009 | 2005 Suzuki Boulevard C90

1 Answer

2008 Suzuki Boulevard M50 with Squeaky Rear Brakes


hi buddy dust wouldnt cause this problem change the disc and get a softer pad its difficult to understand why this happens but basically metal in the pads cause groves in the disc and the metal in the pads try slotting in these grooves as you brake and this causes squeaking mate

Sep 19, 2009 | 2008 Suzuki Boulevard

1 Answer

Oil capacity


It takes 10w40 oil and 3.2 qts for oil change only and 3.6 qts for oil and filter change.

Nov 10, 2008 | 2005 Suzuki Boulevard C50

Not finding what you are looking for?
2008 Suzuki Boulevard Logo

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...