Question about 2004 Sherco CityCorp 125 Enduro

1 Answer

Hi i have a sherco 80 2004 which will start an run but wont rev after cleaning the carb which all seems fine it still the same??? it will tick over but if you try an rev the bike it will cut out

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Some of the other jets are still dirty or it not getting enough fuel, is the float and seat ok

Posted on Apr 26, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GPX750 Carb Problems


check the carb (throttle) cable lengths.If they are different the mixture and idle settings will be meaningless.

Jun 19, 2013 | Motorcycles

1 Answer

Sherco running rough


strip and clean carb and clean out tank , replace plug and ht cap !

Mar 17, 2013 | 2011 Sherco ST 08

1 Answer

Cant get to run


put some fuel down plug hole then try and start it and if it fires but dies then clean the carb as you mite not be getting fuel !

Jun 10, 2012 | Sherco Motorcycles

1 Answer

Vfr 400 nc30 misfire


hi all got a nc 30 vfr 400.strugle to start it there is spark on all 4.have to hold the start in for like 1-3min then it starts ony if i give it some revs but it doesnt rev past 3000rpm it just dies and doesnt start for like a day then same story again.dont know if it is carbs of what

Feb 26, 2012 | Motorcycles

1 Answer

Suzuki lt 50 quad starts and wil tick over but when u try 2 rev it she bogs down and cuts out like a blo9cked carb but i'v had the carb off and its all clean and fine


I got a Suzuki lt 50 it starts fine drives fine at low speed then when I go over half throttle it bogs down I've cleaned the spart plug cleaned the carb and cleaned the jets but its still doin it any ideas please ??

Sep 16, 2011 | Suzuki GSX 750 ES Motorcycles

1 Answer

Hi i have a yz125 an it seems like its missfireing it starts fine an tickes over. it just when u go to ride it its spluttering like hell if you slip the clutch an get revs up hight it will go but...


Was it sitting around all winter? Try cleaning the carbs- usually means replacing o-rings and gaskets, possible even jets if really clogged.

Mar 13, 2011 | 2004 Yamaha YZ 125

1 Answer

2001 r1 not been run for 14 months started it up not responding like it should.emptied tank n put fresh petrol in seems to respond better higher up the revs but wont tick over getting a bit ov back fire.


Try cleaning out your carb, Petrol starts to form into a jelly after 3 to 4 weeks if you dont turn the engine over. Your carb is situated under your petrol tank. Hope this helps

Jun 22, 2010 | 2001 Yamaha YZF-R1

1 Answer

I have a 1986 yamaha virago 700 that wont run properly


2 things need to be done first start your bike get a can of wd40 after your bike is warm and running spray around the carb jointsall 4 of them if your engine changes rpms up or down you have a intake leak ether your carb joint gaskets or o-rings need replacing or your carb joints are old and need replacing. at this point wont hurt to have you carbs cleaned also

May 03, 2010 | 1985 Yamaha XJ 700 X Maxim

1 Answer

Fzr 250 Wont rev when cold


Hi!!
Firstly clean the air filter.
and then the carb too needs cleaning.
You can use a good fuel addative to clean the carbs.
There is a YESI a tube that runs upwards from after the carbarator ... if there is any kind of leak in this you will need to change it immediately..
An advice...Pls dont ty to fix any leak on this using any type of solution, it ALWAYS backfires....
Regards
Berry

Regards
Berry

Jan 31, 2010 | 1987 Yamaha FZR 250

1 Answer

Suzuki GSF400 Bandit problems with tick over.


as you have replaced carbs you will need to retune for fuel intake also check its getting enough air ie.. air filter has been changed or is clogged

Jun 16, 2009 | 1992 Suzuki GSF 400 Bandit

Not finding what you are looking for?
2004 Sherco CityCorp 125 Enduro Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sherco Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Sherco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...