Question about 1997 Honda CBR 600 F(3)V

1 Answer

How much oil goes in when doing a full oil change with new filter?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 653 Answers

Should be abt 3.5L or to be safe just fill about 2.5L then using the cap dipstick check the level indicator.

Posted on Apr 26, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How much oil do i put in after changing oil filter

If you do not have a spec start putting 1 qt at a time in. Check the dipstick each time until you read full. Start the engine and it will fill up the filter. Recheck the oil level and top it up until it is full. Write down the amount you use so you know next time.

Dec 31, 2013 | 2006 Opel Vectra 1.8

1 Answer

I have new pulsar 150 which run 2500 km's . I

Oil change intervals for motorcycles depend a great deal on your riding conditions and riding style. For lower-revving street bikes, I often change my oil about every 2000 miles (~3200 km). However, someone with a sport bike who regularly revs their engine closer to the redline, I would suggest a more frequent change interval. Off-road / dirt bikes should have their oil changed sooner because of the dusty conditions. The oil is still full of lubricants, but it is contaminated with dust and dirt that clogs the filter and eventually goes right into the engine, increasing wear. I can't offer much guidance for dirt bike oil change intervals.

Dec 06, 2011 | 2011 Bajaj Pulsar 150

1 Answer

How much oil does my 03 fxst hold ?

It holds three quarts of engine oil with a filter change. When you change the oil and filter, pour three quarts in the tank and start the engine up for one minute. With the bike still on the side stand, check the oil. The level should be between the lines. Do not "top it off". As long as the level is between the lines, whether the oil is hot or cold, do not add oil. Only add oil if the level goes below the lower line. The top line is "FULL HOT" and the lower line is "FULL COLD".

Good Luck

Jul 31, 2011 | 2003 Harley Davidson FXST Softail Standard

2 Answers

Oil light comes on at idle, goes off when driving, oil level full

change oil pressure switch it' should be near the oil filter

Dec 25, 2009 | 2002 Jeep Liberty

2 Answers

Changing oil van is supposed to hold 4.5 quarts but at 3.5 its over max line

are you changing the filter ?
are you allowing for all the oil to drain out ?
did you start the engine at 3.5 than shut off wait & recheck ?

Oct 17, 2009 | 2003 Chevrolet Astro

1 Answer

Dont no where oil goes or how much on yamaha 450yzf 04

hi buddy on the right side casing on the engine you will see the oil plug unscrew this and refill until the oil reaches 1/2-3/4 full on the sight glass this pic will help ya bud also normally before i use new oil i would change the oil filter so number 1 is the filler plug number 2 is the oil filter and number 3 is the sight glass4476117.jpg

Sep 10, 2009 | 2004 Yamaha YZ 450 F

2 Answers

I changed my oil and filter now oil is leaking

you put to much oil in. drain some off. some oil in recirculated through breather hose's going to the air filter. If u over fill more goes in then can be handled and it drips out of airfilter and onto bike. dont put in a full 3 qts just 2.6

Jul 05, 2009 | Harley Davidson FLSTC Heritage Softail...

1 Answer

Low oil pressure light goes on until car warms up. Oil level is good

The oil pressure sending unit has gone bad. I sending unit is just above the oil filter and you can get to it from the top. When you face the Engine look down towards the oil filter, the oil pressure sending unit is just above that and it looks like a cylinder with two wires coming from it. If you don't see it, it's right between the exhaust manifold and oil filter.
If you go to Auto Zone or Parts Source, they'll have the oil pressure sending unit and the step by step instructions, When installing the new sensor. Do not use teflon tape or any sealant, the sensor is tapered and need's the good ground from the engine to give you right readings.
Good luck and hope this helps.

May 11, 2009 | 2001 Oldsmobile Aurora

1 Answer

Oil filter requires changing

start by dropping you oil and make sure you engine isnt hot you oil intake this is where you pour you oil in then get a new oil filter and seal it with some bnew oil and replace the old oil filter thentighten up the sump plug which you had to remove to get rid of you old oil and tighten up your new oil filter and fill up oil up to full mark on dip stick hope this help jason

Apr 22, 2009 | Toyota Yaris Cars & Trucks

Not finding what you are looking for?
1997 Honda CBR 600 F(3)V Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

76673 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides