Question about 2000 Harley Davidson XL 1200 C Sportster Custom

1 Answer

Will not rev up in gear sat a long time - 2000 Harley Davidson XL 1200 C Sportster Custom

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 623 Answers

More than likely the carb is gummed up, you can try some carb cleaner in the gas tank, but more than likely it will have to be removed and cleaned out. Sorry. Try something called "Sea-Foam" in the gas tank as well if the carb cleaner does not work, then go to the removal.

Posted on May 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gsxr cuts out


replace the fuel pump or adjust the TPS. It doesnt do it in nuetral its because it is not under a load. Put in dealer mode to check the TPS. It should read -COO... If the - is not in the middle (if its up top or on bottom) it needs to be adjusted.

Mar 30, 2014 | 1998 Suzuki GSX-R 600

1 Answer

2000 gsxr600y Flat spots and rough running at 8 and 11 thousand rpm, won't pull passed 11000 from 4th gear up as running so rough


Full disassemble of carbs is needed. Thorough cleaning on jets and airways, vacuum and pilot screw adjustment must be done too.
Check the spark plugs for lean mixture indication and replace them if necessary.

Oct 20, 2012 | 2000 Suzuki GSX-R 600

1 Answer

How do you unseized clutch plates gl1000 75 sat 10yrs creepy in gear


HiClutch not disengaging
Make sure cable has only a couple of mm play. If unable to adjust at handlebars then adjust at clutch endA quick & dramatic way to unseize clutches is to put front wheel up against a wall or similar, bike at 90 degrees to it, front brake on, with full riders weight on seat, in neutral hold clutch in & handlebars straight, rev her up to 3 - 4000rpm, brace your arms & dump her into 1st gearThe shock will generally free-up even a completely seized clutchThe other option is to strip & clean the clutch plates
Ride Safe
Bike-Doc

Jan 08, 2012 | Honda GL 1000 (K1 Motorcycles

1 Answer

,battery went flat, car sat for 2 months,idling too fast and lumpy, on start up and doesn't go back to correct idle, revs high when changing gears


Possibly faulty idle air control valve or vacuum leak. Hard to tell without actually looking at the car, but start by looking for vacuum leaks.

Mar 06, 2011 | 1998 Audi Cabriolet

1 Answer

Clutch


Hi, you might find the nut holding the clutch basket onto the shaft has come loose, so instead of pulling the clutch plates apart you are just pulling the clutch basket along the shaft.
or if the bike has sat for a while you might find the clutch plates have stuck together, this isn't that rare, you can start the bike and roll it along at about 1st gear speed, then click it into gear, then pull the clutch in and rev the engine, this should make the plates loose again. hope this helps, please rate, thanks, good luck

Jul 23, 2010 | 2004 Suzuki RM 125

1 Answer

1990 lincoln town car 5.0, hard to start then


air idle control motor probably sticking remove motor and spray w-d-40 inside then reinstall and tap with a hammer while running

Dec 07, 2009 | 1990 Lincoln Town Car

2 Answers

Car revs high when not in gear, but still revs


Timing has been adjusted to high, or the spark advance is out of adjustment causing the revving

Jul 09, 2009 | 1989 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
2000 Harley Davidson XL 1200 C Sportster Custom Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...