Question about 1997 Honda CBR 600 F(3)V

1 Answer

I have 97 cbr 600 f3 and apparently we took my gas tank off to repair my idle adjust screw does wnyone know where the gas lines hook back up?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 653 Answers

Easiest way to find out is fill some petrol into tank and see where it drip out from. Good enough help?

Posted on Apr 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replace the regulator rectifier and the plug to the rectifier on my 1995 Honda CBR 600 f3. soon as the bike warms up wants to die. so I unplugged the rectifier. brand new battery two. Still Dying


Hi, Harold it's really tough to answer any of your questions because you didn't ask any, the batteries in my crystal ball are dead and my mental telepathy headset is broken so here is my best shot the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. The gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
1995 cbr 600 F3 problem PLEASE HELP CBR Forum Enthusiast forums for Honda...
cbr600f3 will only start choke gas givin Honda Motorcycles FireBlades org
HONDA CBR WONT START TRY THESE TIPS
1996 1998 Honda CBR600F3 Service Manual Moto Data Project

May 10, 2016 | Honda Motorcycles

1 Answer

Cbr f3 inconsistant idle then dies after awhile of riding


only a mechanic with eyes/hands on capabilities can assist you with this

Aug 12, 2017 | Honda CBR600F2 CBR600F3 CBR600 CBR 600 F2...

1 Answer

2001 Honda CBR 929 RR Fireblade replace fuel tank


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Fuel tank removal CBR 929rr
Maintenance Gas Tank Removal 1998 Honda CBR 600 F3
http://www.cyclechaos.com/images/9/97/Honda_CBR929RR_Service_Manual.pdf
https://www.partsfish.com/page/oem-parts-for-honda
Honda CBR900RR FIRE BLADE Owner Manual

Nov 30, 2012 | 2001 Honda CBR 929 RR Fireblade

1 Answer

1996 Honda CBR 900 RR Fireblade will not idle without choke on


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the blue links below. Good luck and have a wonderful day.
cbr600f3 will only start choke gas givin Honda Motorcycles FireBlades org
F3 won idle without choke CBR Forum Enthusiast forums for Honda CBR Owners
Honda CBR900RR Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR900RR FIRE BLADE Owner Manual

Mar 05, 2012 | 1996 Honda CBR 900 RR Fireblade

1 Answer

1996 CBR 600 F3 quits running while riding


Hi, Noor_mansoor and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Air/fuel mixture screw improperly adjusted.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.fireblades.org/forums/honda-cbr-600/85825-1996-cbr600f3-runs-then-quits-running-2.html
96 cbr600 f3 dies while riding on highway CBR Forum Enthusiast forums for...
1996 1998 Honda CBR600F3 Service Manual Moto Data Project https://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F Ower Manual

Nov 16, 2017 | Honda CBR 600 F Hurricane Motorcycles

1 Answer

1996 Honda CBR 600 F(3)T quit running while riding


Hi, Haleys869 and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Air/fuel mixture screw improperly adjusted.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Lean angle switch is faulty or needs adjustment.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.fireblades.org/forums/honda-cbr-600/85825-1996-cbr600f3-runs-then-quits-running-2.html
96 cbr600 f3 dies while riding on highway CBR Forum Enthusiast forums for...
Honda CBR600F4I 2001 Service Manual
https://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F Owner Manual

Nov 04, 2017 | 1996 Honda CBR 600 F(3)T

1 Answer

Whats the newest gauge you can hook to a 97


Brother with a bike you can do anything. I'm running a digital 08 cbr f4i guage cluster on my 97 cbr 600 F3 stunt bike. Just takes skill and know how. Hit me up if you would like an explanation. If I don't answer. Leave a message. I do not get texts. 702-572-4754 Mo

Jul 07, 2009 | 1997 Suzuki GSX-R 600

1 Answer

How do I adjust the rear tire on a 97 honda cbr 600f3


40mm slack up and down middle of chain. not tight when sitting on bike. loosen axle ajust both sides evenly, retighten axle install new split pin

Dec 04, 2008 | 1997 Honda CBR 600 F(3)V

Not finding what you are looking for?
1997 Honda CBR 600 F(3)V Logo

Related Topics:

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...