At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Measure the center pipe from the sprocket to the seats mounting hardware stem. Allow 5 inches for the legs to pedal so the center frame bar must be 27 inches or less for you to ride this bike correctly
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Are you just trail riding, or do you get into any technical stuff? I'm 5'10" with a 32" inseam, and ride a 19" Cannondale. I've got just enough clearance for my friends, but my margin of error is small. You can lower the seat, but you can't raise your ballz. Also, make sure that the cockpit (I see a theme developing) isn't too long for you. You don't want to be in a position where reaching for the bars is uncomfortable. A shorter stem is no substitute for good fit.
if the bike has gears it does not have a master link, that is for single speed bikes only.
You will need an 8spd chain for your bike (1/2" x 3/32), these will fit any 6,7 or 8 spd bike. This requires a special tool to install ($8-$25), I would recommend taking into a bike shop and have them do it if you have no experience with this type of chain.
Side note: if you do own the tool, you can repair a broken chain for a temporary fix in the future, so may be worth buying. Check around, many bike shops offer basic repair classes and cover this.
You will have a very difficult time getting it low enough to fit you adequately. The seat height is nearly 32 inches stock, so compare that with your inseam and see how much you would need to adjust. It is doubtful you will get the bike that low without ground clearance and fender clearance issues, safety aside.
But, to answer your question:
The front fork tubes can be slid up the triple clamps over an inch, sometimes as much as 2 inches. Your fender may need to be removed however.
The rear you will have to buy/fabricate a lowering link set. There are several styles available on ebay.com for your bike.
I would also recommend taking your seat to an upholsterer and having some of the foam removed to provide more clearance for you.
Be advised that all modifications to the ride height of your bike adversely effects your ride quality and control. The amount that you need to lower your bike could and likely will make it much more difficult to maneuver due to the skewed suspension geometry. Please be careful!
I think the 696 is 30" or 31". If it helps, my inseam is 31" inches and I can easily flatfoot it (lots of bend in the knees).
It's taller than my 695 for sure--even with the touring seat.
before spending money on a new sit contact the dealer and see if there is a lowering kit for it. I have just lower my wifes 2007 vulcan 500 by 2 inchs. or talk to www.scootworks.com there are really great there
what are your experiences and what size did you use?
I have one its the size recommended on their website.
Its worth its weight in Gold on a long ride at least with the short seat, like I have. It doesn't take much air to be comfortable and will add only about a half inch to your inseam.
I read a review once where they had it on a sport bike and the reviewer didn't like the way the seat would move under his Butt. Personally I like the feel of the air chambers compensating to the changing load. Almost like a gentle massage.
I won't take a long trip without it. If its 100 miles or more its the first thing on the bike,,,
×