If you remove the pump turn it upside down to shake out the coins Its secured by two screws cross head or philips......Remove the 2 hoses use an old towel to mop up the water from it ...quite straightforward.Good luck...
Fl code indicates an overfill condition. If the washer is empty, then you likely have a problem with the water level pressure switch. If the washer is full of water and will not drain, you likely have a problem with the drain pump or the washer drain line.
If the washer is full of water, make sure that the washer drain is clear and working properly. Check the drain hose for kinks or clogs. If you find no problems with these issues, I recommend that you manually drain the washer using a wet/dry shop vacuum. Check the drain pump and connecting hoses for problems. You may need to replace the drain pump of water will drain out of the washer properly but the pump will not work properly. A clog in the check ball assembly at the bottom of the tub can also prevent the washer from draining properly.
Hi
Ld error indicates long drain and flashes when the
water level will not change even after the drain pump is on. To resolve this
please make sure that the drain hose is not clogged and the pump is working. To
gain access to the drain pump you can lay the machine on its front then remove
the drain hose and replace the pump if the impeller has gone bad. Please post a
comment if need more help.
Thanks
Rylee
608 views
Usually answered in minutes!
×