1995 Dodge Dakota Logo

Related Topics:

Anonymous Posted on Mar 25, 2010

No fire. it ran fine, parked it for the night. Next day it would'nt start. It turned over but would;nt fire. I gave it a shot of ether, still would'nt fire. replaced crank sensor. It still won't fire. Help !

  • Anonymous Mar 27, 2010

    I put a new distributer pick-up,wires &pluges, cap&rotor, PCV filter,air filter,& coil. On my 1995 dodge dakota 4x4/ V-8 Ex-cab. And Iam still not getting spark.And I checked all fuzses-ok-. What other suggestions do you have for me?

×

1 Answer

A

Anonymous

Sensor in Distributor?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Will not Start after running two days

Try pulling engine codes , possible crank sensor.
0helpful
1answer

96 GMC Yukon won't turn over

Thats what i would try and if that dont help, maybe check the connections at the starter.
0helpful
1answer

2006 Expedition ran great, parked over night, would not start, battery checked Okay

See if you can jump start the car from another battery which is sound. If you can then the battery you have is rubbish and must be replaced.
0helpful
1answer

Won't start was running fine in rain next day no go

It is probably water has gotten into one of the sensors and needs be disconnected and dried out. the only way to distinguish which sensor is to have a tech connect a diagnostic meter to the vehicle.
1helpful
1answer

1995 Pontiac Grand Am won't start

is it poss the engine is flooded with fuel? if you can remove the spark plugs see how wet they are. If wet, replace turn engine over while they are out remove fuel pump fuse and coil pack conector b4 you do this if unable to do this hold the gas pedal down all the way to the floor your vehicle is fuel injected this will create a fuel shut off mode which while held down will not deliver any fuel to the engine as the engine starts to fire and run rough take you foot of the pedal ane nurse it until it runs ok if it runs get your mechanic to check for leaking injectors dripping over night
0helpful
1answer

I have a 1999 dodge mach 3 conversion van, v-6 3.9. It has been stalling off and on and sometimes in the morning would not start like it was flooding up... I cleaned the IAC motor and ran fine for a week...

try replacing the camshaft positioning sensor.this little sensor can cause you more headaches then an exwife but at least the sensor is easily cured,any way start there its inexpensive and a fairly easy job.Hope this helps good luck.
0helpful
1answer

2000 mazda MX-5 1.8l

Have you checked that you have power to the coil on cranking?You may also want to check wether you have a good strong spark at the spark plug.It could be an ignition module breaking down.If you have no power to the coil you may need to change the ignition relay.Its close to the battery.
Not finding what you are looking for?

191 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...