Has not been driven on 10 yrs..stored in heated storage. what should the 1st step be to getting it going again?

The engine in this car is controlled by a computer, whenever a problem like this occurs you must have the electronic engine control computer checked for fault codes as the 1st step in diagnosis and repair of the problem.

ignition control modual is going bad, They last about 10 yrs . when they heat up ,they short out and quit operating until they cool down..Go to the auto parts store and check prices before you purchase it. They are a non returable part because they are electrical, so check around before you buy one.Get the best price and warranty..They are not that hard to change out,if you can handle a screwdriver you can do this.If you take it to a shop, then no more than 30 min. repair...max....

If you are using the KX-T7730 phone on a Panasonic KX-Txx 308/824 system. From the Switcboard / Main telephone ( usually ext 101, 10 or 9 ) with the handset on the cradle/hook :
1. Press PROGRAM * # followed by the system password ( default is 1234).
2. Now press 001 and then SP-PHONE. Enter the system speeddial location ( 00 to 99 ) or just press SP-PHONE again to go to 00.
3. Enter your line access number ( usually 0 or 9 ) followed by the telephone number you would like to assign for the speeddial.
4. Press AUTO DIAL / STORE to save your setting.
5. To go to the next speeddial location press SP-PHONE and follow steps 3 and 4 again.
6. Press PROGRAM to exit program mode.
7. To dial the system speeddial from any extesion lift the handset and press * followed by the speeddial location ( example 00 )

sounds like u have a bad overheat sensor on the back on the electric strip housing and on fan housing they are round they are very cheap just take them off and replace both of them and that should fix your problem

unless youve done your regular maintenance-change trans oil ajust shifting cable and test solenoids-u r in for a rebuild-all the moving parts get heat varnish on them from 10 yrs + so go ahead and see 1st if adjustments help-get a manual-maybe your just low on fluid

After 8 yrs..........Get a life and new printer! Inkypete

George, make sure the belt is not loose flapping around making all that noise.

Not hard to change if you can get one from an hvac friend, they won"t sell to homeowners normally.

1st approach (Quick one!)

1. Soft reset your device
2. make a backup copy of the folder \SD-MMCard\MSMETADATA if exists.
3. delete the folder \SD-MMCard\MSMETADATA.
4. Soft reset your device once again.


2nd approach (Long one!)

If 1st approach did not work, restore the MSMETADATA folder and try the following:

Step Zero: BACKUP
- Make a full backup of your device (including storage cards). If you don't like to do a full backup keep at least a backup of all files and folders we are going to delete as indicated below:

Step One
-In the main device directory delete the file WMPInfo.xml
-Delete the \Application Data\Microsoft\Media Player\ directory and all of
the files in it including the WMDRM folder.
-Delete the \Music folder

Step Two
-Go to your SD card main directory and delete the file WMPInfo.xml
-Delete the folder \SD-MMCard\MSMETADATA
-Delete the folder \SD-MMCard\WMDRM
-Delete the folder \SD-MMCard\Music

Step Three
-Repeat step two for any other storage cards.

Step Four
-Refresh devices in WMP and the storages card should show up in the left tab
and in the sync window you can click "Next Device"

Hope this helps...

the water must drain out of the tank b4 it can spin make sure the pump is working ok