Please help me to remove the front seat of my suzuki TL 1000r. I just want to take the seat off so I can put custom leather on it. IS THERE BOLTS OR WHAT I JUST PURCHASED IT 2 WEEKS AGO !!!!!!!!

F1 is no fault. put into dealer mode the little white connector under the rear seat, a bit of wire bridge the terminals and a fault code will come up, if you put a retarder on the bike try putting back to std

Have you asked Suzuki?

Common on a lot of bikes my v max h\d this problem, check the earth cables, and maybe replace with a thicker on.

There's one bolt at the back of the pillion seat, release that and slip the rear seat out of its leather loop. The loop and the front seat are held on by two bolts, with those removed you can slip the driver seat out of its hook under the tank.

Which fuse?

If you need further help, I’m available over the phone at https://www.6ya.com/expert/oscar_403cc49e0f00cda7

hi done 1 of them a week ago absolute nitemare, remove airbox remove throttle bodies very fiddely to conect the cable between the throttle bodies, hope this helps

front one I take it, undo radiator and fiddle till you get a plug spanner in, a pain in the bu77

The only way to tell without taking it to a shop with expensive equipment would be to take the timing cover off, check the timing marks on the cams and make sure the crank is lined up at the same time. You have no control over the advance, it is all done by computer, I don't even know how your engine is set up, even though I almost bought one of those bikes, I was ignored at the dealer so I went across the street with my pocket full of cash to Athen's Ducati, I'm glad they ignored me. I found this;
http://www.d-slr.com/tl1000r/TRE-3.pdf check it out.

10w-40w

this is a link to a diagram for your waterpump you can also order parts from this site.
http://www.mrcycles.com/fiche_section_detail.asp?section=99148&category=Motorcycles&make=Suzuki&year=1999&fveh=2199