I do not have a motor cycle manuel and I need to replace dust covers and seals and fork oil on a 750 GSX Suzuki 89/90 Model . have you ?
hi, the obviouse thing here is to get a manual, however if you think you have the finess required to do the job its fairly straight forward, put bike on stand, raise the front wheel of ground, remove spindle from front wheel, remove calipers from forks, DO NOT REMOVE BRAKE LINES FROM CALIPERS, once you have done this you can then remove the front wheel, put spindle back through loose wheel inc spacers to keep all in place, remove front mudguard, i always tell people to try and remove the lower fork leg first leaving fork tube on the bike, some forks it is poss to do this as the busshing is fitted to the lower leg and not the chrome tube, undo the bolt in the lower fork leg on the underneath inside where the spindle fits through, once removed, using a container to catch the oil, pull dovn on the lug to remove it, if it comes of all the way you are in luck easy job, the fork can then be cleaned and new seal fitted, the manual would come in handy for fork oil levels,if the leg does not come off you will have to remove the whole leg, before you remove it undo the top nut on each leg as the yokes will hold it for you, it is difficult to undo once the fork is removed, once removed, lift up the dust seal, remove the clip, and then the spring from the top, grip the lower leg in a vice with protective jaws, on the flat surface only, to grab the tube area would damage the fork leg, once in the vice, push in the stancion fully depress and pull out sharply you may have to repeat this sevral times useing the stancion as a hammer until the seal is removed, replace in reverse order,
DO 1 FORK FIRST REASEMBLE THEN DO THE OTHER, hope this helps feel free to contact me, paul
Dec 17, 2010 |
1990 Suzuki GSX 750 F (Katana)