Question about 2001 Suzuki AN 400 Burgman

Open Question

Trying to release a siezed hand brake on a suzuki an 400 scooter cannot seem to remove fairing

Posted by on

  • kkpp2 May 11, 2010

    Here is your solution » Honda »
    Suzuki » Yamaha » kawasaki a

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pride Celebrity x. Batteries drain quickly despite new full charged batteries. When scooter is pushed in freewheel- brakes engage every few feet. Have to turn scooter on/off to get brakes to release.


hi Diane, the brake engaging is by design, distance is the key here

Have you tried another charger ?

1. when pushing the scooter in freewheel before the brake engages , is it easy to push ? what can happen is the brake does not release 100%, a easy test is to run the scooter then put your hand on the brake unit , is it hot ? be careful because it could be very hot , this will prove the brake is not releasing fully.

Regards
Rob

Dec 09, 2015 | Pride Health & Beauty

1 Answer

One wheel is locked as though a break is on i have put oil round the spindle but seems siezed up


Depending on how long it sat, it may be the brake is locked up. The fix depends on if it is disc or drum, but there could be other causes to this problem too. Have you tried reversing?As you may be needing the scooter, you may not be able to do the testing needed, so getting someone physically capable would help. I do not recommend trying to force it - it could be more than a bearing or brake lock up, and forcing could potentially ruin the scooter. As there are too many different configurations to be able to diagnose here, your best bet may be to take it to an experienced pro for repair. I understand funds are likely tight (like they are for most of us it seems) but repair would likely be cheaper than replacement.
Hope this helped!!

Jun 12, 2015 | Health & Beauty

1 Answer

Cant start my Celebrity X scooter. Seems to drop into free wheel on power demand.


Are there any fault codes? if so check your manual. Is the speed setting turned down low?. The click is the brake releasing so that's ok. Motor brushes may need attention.

Mar 21, 2015 | Pride Celebrity X 3 Wheel Scooter

1 Answer

I HAVE A 2008 SUZUKI BURGMAN AN400.AND NOT A 2003........ HOW DO YOU GET TO TAIL LIGHT AND BRAke LIGHTS WITHOUT HAVING TO TAKE HALF OF TH SCOOTER APART


Remove up and lower plastic cover, on the back of the bike. Just give them a pull, toward the back of the bike. They are just fixed with plastic clips.
It's very easy and handy. For the light bulbs they come off with a quarter twist. :)
CRPT - Portugal

Aug 29, 2010 | 2003 Suzuki AN 400 Burgman

1 Answer

Strider cart wont go battery full has something to do with handbrake


mcdevito75, You can try to apply and release the hand brake, In any case have the hand brake checked out as the cable could be stretched.

Jun 21, 2010 | Electric Strider Maxi 4 Wheel Mobility...

1 Answer

Shoprider laid up for a couple of months Now only goes click


Hi Nigel. Sounds like the brake assembly ( Free-wheel ) is not releasing. Can you manually release the free-wheel and push to scooter? If you cant push it the the brake solenoid might be the fault. I have had a few over the years that have done this. The resistance through the coil should be approx 50 ohm's.
Otherwise the motor might be burnt out. Motors that are burnt out give a very distinctive burnt varnish smell. Good luck. Neil.

May 31, 2010 | Shoprider Sprinter XL4

1 Answer

Led Flashes 5 times - Brake in freewheel or brake connection problem. How can I fix this?


Pull the key out of the plug or key switch. There is a freewheel/brake release lever sticking out of the top or back of your scooter on the driver's right hand side. Push this handle the opposite way it is now and try the scooter. If this does not work, repeat the steps above. It is important to do this with the key out of the unit or it will not reset.

May 10, 2010 | RTO Golden Buzzaround Lite Scooter Meets...

1 Answer

Where is battery located on burgman 400 scooter


Open compartment just below the instrument cluster with the ignition key. on right hand side is a small cover held on by jis (Phillips) screws. Remove the panel and the battery will be in plain sight with the terminals at the front bottom. Remove the retaining clips and leads and then you can take out the battery and charge or replace. Reverse the process to replace.

Mar 31, 2010 | 2001 Suzuki AN 400 Burgman

1 Answer

I need a starter motor for a suzuki an400, year 2000


try to check the e-bay for that one they have a second hand parts in for for a low cost.

Jan 01, 2009 | 2003 Suzuki AN 400 Burgman

1 Answer

Engine


Hi - sorry to hear that the endine is not fit. As far as a replacement is concerned, you don't say which country you are in. Here in UK there are a number of dealers that deal in crashed/repairable bikes - they can be found in the ads at back of motorcycle magazines. Also, we have magazine called Exchange & Mart that is OK for speares (but Nurgman is fairly rare bike). Other place is eBay. As for other sizes, my understanding is that the frames of the 250 (possible replacement) and 400 are not same. 650 definitely will not fit.

Nov 10, 2008 | 2001 Suzuki AN 400 Burgman

Not finding what you are looking for?
2001 Suzuki AN 400 Burgman Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4533 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...