Question about 2004 Yamaha TT 600 RE

1 Answer

Just cleaned carb for 99 grizzly 600 and it runs for a min or so and then dies same problem happened before i cleaned the carb

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 40 Answers

Check for a steady supply of fuel to the carb. Could be a blocked or pinched fuel line. Very possible that the float needle and seat are worn, causing the valve to remain closed or partially closed. When this happens the fuel bowl runs out of fuel causing the engine to die. Then fuel trickles back in while sitting and slowly fills the bowl again, allowing the engine to restart. Also be sure that the float level is set properly and that the float pivots freely. Most small engine carb floats are set to shut off the fuel when the float rises in the bowl to where the flat surface on the float is parallel to the bowl mounting surface. If the float is set close to this, don't try to adjust it. If your float needle has viton (rubber like) tip, be sure that it is not deformed. Never press on the needle because it will deform the tip, causing the valve to stick open or closed. Many times you can buy just the float needle and seat either OEM or aftermarket.

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 Yamaha Grizzly 600 runs for 5mins. and dies. Engine won't turn over for short period and then starts. This cycle continues.


fuel flow to the carb is slow. fills the bowl, runs till its dry. pause while it refills slowly, repeat.

Feb 21, 2017 | ATVs

1 Answer

Yamaha grizzly problems


remove and clean carb... and clean it very well making sure nothing is corrodid

Aug 28, 2014 | ATVs

1 Answer

2007 grizzly 700 was running fine for about 5 min. then died now it wont start, turns over fine but only backfires


possible blocked carb- also check ohms reading on sparkplug cap should be no more than 8 ohms

Jan 19, 2013 | Motorcycles

1 Answer

Hi im having problems with my 99 Fazer 600 (15k). After about 30 mins of motorway riding the revs die for a few seconds and then kick back in, everything electrical seems to carry on working. It will run...


First thing I would do is try draining the carb floatbowls incase you have water or dirt in the bowls and when you crack open the throttle it's drawing water/dirt into the jets.
have you checked the plugs? in the haynes manual as 10K-Ohms @20c
When was the last time the carbs were balanced?

hope this helps

John

Jun 12, 2011 | 1999 Yamaha FZS 600 Fazer

1 Answer

My fazer 600 w plate when i give it a good hand full it burbles and dies and then wont start for a good 3 mins when it restarts it seems to have more power this also has started to happen when riding...


If the carbs were jetted for a different pipe,and you have changed it back to standard that will cause your symptoms,if it was doing the same before you changed the pipe your carbs need cleaning

Mar 17, 2011 | 1999 Yamaha FZS 600 Fazer

1 Answer

Hard to keep running


how long has the bike been sitting?? It sounds like your carbs are blocked up and need to be cleaned and synchronized.
good luck
Mark

Apr 28, 2010 | 1996 Suzuki GSF 600 S Bandit

1 Answer

99 CBR will start but wont run


did you check the fuel filter and fuel supply?

Jun 14, 2009 | 2001 Yamaha V Star 1100 Classic

Not finding what you are looking for?
2004 Yamaha TT 600 RE Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...