Question about 2003 Suzuki GZ 125 Marauder

Open Question

Suzuki marauder 125 2006 choke cable stuck Hi Trying to free the choke cable... How do i remove cable from the carb... Thanks Paul

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2336 Answers

SOURCE: wiring diagram

The Haynes Service and Repair Manual ISBN 1844252787 has the wiring diagrams for GZ 125 Marauders from 1998 to 2005.

Posted on Nov 10, 2008

centurion_BB
  • 83 Answers

SOURCE: 97 suzuki marauder fork seals problem

Normally no. If the fork seals are leaking when you ratchet the front down on the trailer your seals were bad prior to that. If you are talking about the straps being wrapped around the forks the only thing that they would contact would be the dust covers. The fork seals are actually down inside the fork about 1/4 inch. Have a good day

Posted on Aug 12, 2009

  • 269 Answers

SOURCE: where i can download free suzuki marauder 125

Manuals are copyrighted material, sadly you cannot legally get them from a download. Just stop by your dealer and pick one up.

Posted on Sep 16, 2009

  • 85 Answers

SOURCE: suzuki marauder 125 oil change

Drain plug is in the center of the oil strainer cap,aka round spoked attachment

Posted on Apr 06, 2010

  • 901 Answers

SOURCE: Carb Problem GZ 125cc

First check the throttle cable free operation. Check rubber manifold couplings for air leak. If programmable firing control is used check the switch. Refer user guide.
Check program switch operation. This is coupled to the throttle cable. This switch sets the ignition timing advance or ******. This is called power mode operation switch.

Clean the carburetor with diesel or kerosene. Do the cleaning out-doors. Clean all the jet orifices with air. Use correct tools. Especially the flat blade screw driver tip.(end should not be sharp )

Note down pilot jet air screw position. Note the number of turns you screw out. This is needed for resettling the air screw. If it is a CV carburetor check the rubber diaphragm for stiffness or damage.

Needle jet is coupled to this diaphragm. Throttle cable opens the circular gate only. Due to velocity of the air the diaphragm positions the needle. Try the easy checks first. Finally main chain tension. Follow the solution given by Fixya GURU also

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Suzuki Gz250 high idle always. Turned white knob out all the way and it still idles high. Has auto choke. Any ideas?


Hi, Galen and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
10. Multi carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
idle speed adjusment for motorcycle suzuki gz250
Suzuki GZ250 Service Manual "FREE"
OEM parts for Suzuki
Suzuki GZ250 Owner Manual "FREE"

Oct 15, 2016 | 2003 Suzuki GZ 250 Marauder

1 Answer

Suzuki 800, 1997 carb floats stuck


the floats are easy to fix...getting to them is the problem. the old gass has gone bad and will not ease up if new gass added.
remove carbs undo the 4 retaining bolts on the bottom of the carbs spray with carb cleaner free them up by hand (try not to adjust anything) and replace on bike !

Apr 27, 2013 | 1997 Suzuki VZ 800 Marauder

1 Answer

Where is the choke on a Suzuki marauder


Your choke is a pull out knob located under your tank; it is not a part of the carb. You might be able to trace the cable from the carb to the pull out knob.

Feb 26, 2013 | 1997 Suzuki VZ 800 Marauder

2 Answers

Runs good at idle wont rev after quater thottle bogs .revs good if choke is on


HI,,,you have blocked carbs,,they are running lean,thats why it runs better with the choke on,,carbs need to be removed from the bike disasembled and cleaned.

Apr 20, 2011 | 1977 Suzuki GS 750

1 Answer

1997 Suzuki Marauder vz800 stalls


Hi, Abgurkins and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
13. Multi carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
97 Marauder VZ800 Not running right
Suzuki VZ800 engine dies when it gets warm Biker ie Forums
Suzuki 1997 VZ800 Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki

Jun 30, 2017 | 1999 Suzuki VZ 800 Marauder

1 Answer

Chock stuck open


hi most likely the cable is corroded, remove the cable bar end first then unclip from carb end easy job if the cabe is seized the choke will return to its resting position, in this case replace cable, or free off and lubricate old cable.paul

Jan 04, 2011 | 2001 Suzuki GSX 750 F (Katana)

1 Answer

I have bought a 1999 gz250 and the choke cable was boken off and would like to know if i can change carb and where to find the parts i need to fix it help please


well.. you can just buy a new choke cable? if youre having trouble sourcing a choke cable then get a universal one from ebay? and yes you can change the carb, just make sure it has the same fittings ect, and ebay is a haven for bike parts!

Oct 10, 2010 | 2000 Suzuki GZ 250 Marauder

1 Answer

Have a 2004 suzuki marauder. engine starts but


Your idle circuit jet is clogged, you will need to run seafoam fuel additive in your gas tank and see if this clears it up or clean the carbs.

Apr 04, 2010 | 2004 Suzuki VZ 800 Marauder

1 Answer

2003 vz 800 only runs when choke is all the way out and wants t stall when i push it in. Should I clean the carbs with carb cleaner and how do I do that. Thanks new bike owner


rem/carove carb from engine. Choke is on when pushed in? You could run injector / carb cleaner through fuel also. You don't always need to choke

Feb 21, 2010 | 2003 Suzuki VZ 800 Marauder

Not finding what you are looking for?
2003 Suzuki GZ 125 Marauder Logo

Related Topics:

393 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...