-
Contributor
19 Answers
- Posted on Dec 11, 2009
Re: How do you change a fuel filter on a 97 dodge stratus
Fig. 7 Fuel Lines At Fuel Pump Module
NOTE: The fuel filter mounts to the frame above the rear of the fuel tank. The inlet and outlet tubes are permanently attached to the filter.
REMOVAL
- Release fuel system pressure.
- From inside trunk, disconnect fuel pump module wiring jumper from main body harness.
- The 4 pin connector is located under the trunk mat on the left side of trunk near the base of the shock tower.
- Locate body grommet for jumper near base of rear seat. Push grommet out and feed jumper completely through hole in body.
- Remove fuel cap slowly to release tank pressure.
- With vehicle on a hoist, drain fuel from tank. Support fuel tank with a support such as a transmission jack stand.
- Position a fuel approved container, with a capacity of at least 16 gallons, under the drain plug located on the bottom left edge of the tank.
- Remove drain plug and allow fuel to drain. WARNING: Drain plug must be installed at this time as there will be 1 to 2 gallons of fuel left in the tank .
- When tank is no longer draining, install drain plug. Tighten plug to 32 in lb .
- Remove driver's side fuel tank strap.
- Loosen, do not remove, passenger side fuel tank strap allowing fuel tank fill neck to touch rear suspension cross-member.
WARNING: Wrap shop towels around hoses to catch any gasoline spillage .
- Disconnect fuel lines from fuel pump module Fig. 7 . These are quick connect fittings.
- Disconnect fuel supply line from the fuel brake module.
Fig. 8 Fuel FilHow do you change a fuel filter on a 97 dodge - 42402627img src="/uploads/images/42402627" alt="42402627" class="h_mi" />
- Remove fuel filter Fig. 8 .
NOTE: The fuel supply (to filter) tube, return tube (to pump module) are permanently attached to the fuel filter.
- The ends of the fuel supply and return tubes have different size quick-connect fittings.
- The larger quick-connect fitting connects to the large nipple (supply side) on the fuel pump module.
- The smaller quick-connect fitting attaches to the small nipple (return side) on the fuel pump module.
Apply a light coating of clean 30 weight engine oil to the fuel filter nipples. Install fuel tubes.
- Install fuel tank, filter and tank straps. Torque tank strap bolts to 23 Nm (250 in lbs) . Make sure pump module harness grommet is installed in body as tank is raised into position.
- Lower vehicle and connect pump module connector.
- Fill tank with fuel.
- Connect negative cable to auxiliary jumper terminal.
×