Question about 1988 Honda CBR 600 F(1)J

2 Answers

No spark at plug

Ran my cbr yesterday started fine tried today but just keeps turning over took a lead off and got no spark??

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Follow the lead to the coil and see iff the wires have comeon had the same problem the other day

Posted on Dec 10, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 430 Answers

First remove the lead for #3 and #4 cylinder and check for spark on both as there are 2 coils. If no spark on either then it could be a number of ings: a) loose, bad, damaged wire/ connections b) faulty ignition or stop switch c) faulty nuetral or sidestand switch d) faulty pulser coil e) faulty high tension coils f) faulty spark unit

In my experience the pulser coils are the weak link. After checking the obvious check the pulser coils...
remove fuel tank, disconnect the red 4 pin block connector, with a multi meter set to ohmsx100 check the resistence between the white wire/ yellow stripe and the yellow wire and between the white wire/ blue stripe and blue wire.
both readings should be between 450 and 550 ohms at room temperature
if either of your measurements vary greatly from those values then replace the pulser coils.

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont it run?It ran yesterday for a minute until i turned it off.I unhooked neg.battery cable now it wants to start but just tries and pops and backfires thru intake!!!WHY?


Want to help you but can you provide some imfo like year model etc of your car .all cars runs if you have both gas and spark

Feb 15, 2016 | 1997 GMC Suburban

1 Answer

Will turn over but will not start ran just fine yesterday but today nothing. (Will turn over but will not start)


from easy to difficult:
put gas in tank
try starting fluid
check for spark
check timing

Mar 23, 2014 | 1996 Saturn SL

1 Answer

2003 Kawasaki Ninja 12R will not start


the whining is the sound of the starter motor turning...in which case your problem would be a failed starter clutch.

Oct 10, 2012 | kawasaki Motorcycles

1 Answer

My 2002 cbr600f4i will turn over but will not start, it ran fine yesterday i went out this morning and it will not start, any suggestions


i know this might sound a bit daft...but the kill switch on the handlebars is not off?
& has it got petrol in it?
does it try to start?..does it cough & slputer?if it does it may want new sparkplugs..as these seem to go off with repaet running while laid up for winter...if this is not the case...check the plugs for spark & make sure petrol is getting to the plugs!!...hopes this helps....Howard

Jan 20, 2010 | 2002 Honda CBR 600 F(4)i

3 Answers

I just bought a used 2002 honda cbr 954 rr. i cleaned the spark plugs about a month ago and it started up and ran fine. but now i cant get it to run no longer than a few seconds. any ideas what the problem...


Was the bike running fine before you cleaned them? If your bike won't stay running, you might need to adjust your idle. There is a black round dial on the left side next to the stator (big round circular housing) turn it so the fuel is increased.

Jan 11, 2010 | 2002 Honda CBR 954 RR Fireblade

1 Answer

No spark from spark plug


New Saw? Warranty time
Electronic ignition? Replace entire module. Pinched wire to metal case part for ignition switch. Permanently shorted ignition switch--replace.

Jun 27, 2009 | Poulan Pro 42CC 2 Cycle Chainsaw, 18"

1 Answer

Engine runs rough. Engine light on.


Try checking the spark plug, and the spark wires, if that doesnt clear things up then try replacing the roter under the distributor cap and check the cap for any corrosen

Mar 25, 2009 | 2003 Chevrolet Cavalier

3 Answers

CBR 250 not starting


Sound like you have a fuel problem.Turn the key without starting the bike listen for a slight buzzing noise it will come from where the end of the tank and the seat meet this is the fuel pump priming if you can not hear anything then most likely your fuel pump is not working.Your carbi may have grit in a jet a carbi cleaner can help.
I hope this helps!

Dec 08, 2008 | 1997 Honda CBR 250 RR

Not finding what you are looking for?
1988 Honda CBR 600 F(1)J Logo

492 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4912 Answers

yadayada
yadayada

Level 3 Expert

79865 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...