Question about Yamaha XV 535 Virago DX Motorcycles

1 Answer

Hi,my xv535 keep blowing the 30amp fuse with the ignition off

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 83 Answers

You have a massive short. First, start by disconnecting ALL of the components on that circuit. What circiut is that 30 amp fuse on? From there, use a digital multi-meter and check ffrom the connector leads to the chassis ground. You will need a wiring diagram for this, and no, I don't have one for it. Possible to do it without one, but you'll have to trace the circuit by eye or hand. Not too bad on a bike, but in a car, that's a different story. If you have continuity to ground on a circuit that is supposed to be power, you have a wirring short. If you do NOT have a wiring short, you have a component shorted to ground, example, a starter or alternator, etc... the Stick

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 yamaha fzr600r, theres a 7.5amp fuse that keeps blowing, it's in the fuse box on the left side with the main 30amp what's the fuse for?


Hi, Jonathan you have a dead short which is usually the easiest to find. Using a test light connected to the hot side of the blown fuse holder, start probing the wire leaving the fuse holder about an inch away the test light should illuminate, keep probing towards the ignition switch until the test light no longer illuminates you are now very close to the short. For more information about your issue, please visit the websites below. Good luck and have a nice day. https://www.tradebit.com/filesharing.php/search/0/1994+yamaha+fzr600r

Jul 27, 2015 | Yamaha Motorcycles

2 Answers

I have a 1999 dodge avenger that keeps blowing the 30amp engine fuse under the hood it only blows the fuse when I crank the ignition checked all the words not sure where to look anymore any suggestion's


If it just keeps blowing it could either be a bad ground somewhere or theres to much power getting pushed to it for some reason when u start it, blowing the fuse

Jan 03, 2015 | Cars & Trucks

1 Answer

Front HVAC fuse keeps blowing


Could be a bad ignition switch.. needs to be checked by a professional.

Feb 05, 2013 | 2001 GMC Yukon XL

1 Answer

The 30 amp fuse on my bikes solenoid keeps blowing


Hi you have a grounded wire remove the fuse use a ohm meter or battery powered test light test the outgoing lead and to the frame if it lights up or registers on the meter backtract to see if the wire is grounded insulation worn off or pinched on the frame.

Jan 10, 2013 | Honda Deauville NTV 650 Motorcycles

1 Answer

2002 PT Ignition start fuse blowing


PCM?? No they are wrong I think, keep looking at every wire fuse 30 supplies power to, you will need buy the factory wiring diagrams.

Oct 24, 2012 | 2006 Chrysler PT Cruiser

1 Answer

I have a 05 Toro 44in ZTR with a 19HP Kawasaki engine with under 300 hours the main 30amp fuse keeps blowing when I turn on the ignition switch on. I noticed when I disconect the PTO switch the fuse dousnt...


sounds like your electric clutch is prob bad check to make sure wires are not bare touching something, the clutches do go bad eventually like any other electrical part, disc the pigtail and try fuse, if it blows then I would consider a clutch

Jul 27, 2011 | Toro Zero Turn Rider 74833 Lawn Mower...

2 Answers

No spark/no fuel.1995 toy. camry 2.2 5S=FE


The BONNET is the hood, You must have talked to someone from ENGLAND. The fuse may blow if the coil or the igniter is shorted. Turn the key on and disconnect the igniter and coil, then hook up each one and see when the fuse blows.

Nov 23, 2009 | Toyota Camry Cars & Trucks

1 Answer

Blowing 30amp ignition fuse.


first check the wires connected to the battery for missed alignment. then change the fuse to 30 above amp.

May 28, 2009 | 1995 Nissan 200SX

1 Answer

Wiper fuse keeps blowing intermittently.


It looks like the wire circuit for the wiper motor is touching the car body when shaken so the only thing you can do is shake the wires and terminals yourself while engine is running then maybe you can pinpoint where the earthing is.

May 08, 2009 | 2001 Hyundai Accent

1 Answer

Ignition fuse kepts blowing


then there is a short circuit on that node. try to analyze also what was that 30amps fuse for? example, is it for lights, audio, aircon? You also need a simple multimeter to check if it still shorted.

Mar 29, 2009 | 1991 Mitsubishi Galant

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

Tom

Level 2 Expert

314 Answers

vince

Level 3 Expert

1216 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...