Clutch fixed after oil change?

clutch, and check clutch cable linkage. Make sure there ain't no or very little slack in the clutch cable. It dies because the clutch is still engaged with the flywheel. Car won't move in any gear because the clutch prolly needs to be changed.

First off, is it the clutch will not engage or is it the shifter will not move? If the clutch won't let it go into gear without grinding the you may be low on fluid or you have a weak slave cylinder. If it's the shifter itself then more than likely with the cold weather we've been have, the oil in the trans is cold and thick, do not force the shifter, it may break. When was the last time you changed the trans oil? If it's running that thicker oil to keep the whining sound out of the trans then theirs your problem and you should use a thinner MFG approved oil in the cars transmission.

Clutch fluid...check the lines for leaks and what not. In my experience, the clutch is blow....prob need new pressure plate!

There may be an adjustment bolt, called a stopper bolt, at top of pedal. Screw it out and pedal height will change.
Good luck.

the battery wont stay charged? if youre putting in a fully charged battery and your car runs, but then the battery slowly dies, the problem will be your alternator. the alternator is what maintains a car batteries charge. try replacing the alternator. hope this helps.

where the clutch pedal can depress button when stroked to floor look under dash straight in line with pedal.hope this helps.

It sounds to be like you have a syncronizer out on your transmission. This helps your gears mesh without grinding.

check the clutch oil first and then go the clutch plate and if possible check the gear oil and also the clutch

Your bleeder valve is probably not tight enough or is bad. Air is getting back in your system somehow.

piston ring is one reason why no power and burning oil