Posted on Nov 22, 2009

Electric start cliking, lights flicker when running

2008 atv Kawasaki brute force 650 4x4i
electric start cliking only (sounds like solenoied)
pull cord start works fine
when running , if you turn on the lights they flicker and the display shuts on/off a few times,
when the winch is worked the entire machine shuts off ?
is this the battery ?

1 Answer

Anonymous

Contributor 20 Answers
Posted on Nov 22, 2009

Anonymous

Contributor

Joined: Nov 21, 2009

Answers

Questions

Helped

8625

Points

If you have a volt meter, check the battery cables for voltage when its running. if you read above 12 volts, then your charging system is fine - replace the battery. if less than 12 volts, then you have a bad stator winding and will need to have the charging portion of the stator replaced. probably about a $300 part.

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Kawasaki KVF Brute Force 700 with electric start won't start. Cleaned the carb, changed spark plug, and checked for spark. The plug is wet but will not start.

https://quads.ddns.net/service-manuals/kawasaki/2005%20Kawasaki%20KVF%20750%20Brute%20Force%20Service%20Manual.pdf

Read full answer

Dec 05, 2022 • kawasaki 2005 Brute Force 750 4x4i

0helpful

1answer

2013 Kawasaki Brute Force Cranks and dies after running a few seconds.

https://motorandwheels.com/problems-kawasaki-brute-force-750/

This site refer to electrical connections that cause a number of drivability problems. It may or may hot help you solve your problem.

https://www.kawieriders.com/threads/2013-brute-check-engine-light.136233/
This site will help you reset the check engine light.

Read full answer

May 06, 2022 • ATVs

0helpful

1answer

05 750 brute force only starts in gear. Dies when you put it in neutral. Neutral light stays on in any gear. Will only turn over in neutral with brake lever pulled. happened after oil/filter change.

does it die when you give it gas

Read full answer

Nov 04, 2018 • kawasaki 2005 Brute Force 750 4x4i

0helpful

1answer

I have a 2005 brute force 750 won't start with electric start it will start when I pull start it will run.when it's running the lites and display are flickering .

Sounds like your battery is about dead... replace the battery and clean the connectors/wires/terminals.. and a little waterproof grease will stop the corrosion. Make sure the new connections are tight!

Read full answer

Jan 25, 2017 • kawasaki 2005 Brute Force 750 4x4i

2helpful

2answers

Hit the start button and nothing happens 2008 750 brute force

Check your starter solenoid. You can trace it by following the power wire from the battery to the small solenoid block that contains a 30 amp fuse. You can bridge the posts on the solenoid by using needle nose pliers or whatever else you may have. If it starts up or you hear the starter run, you have a bad starter solenoid.

Read full answer

Feb 02, 2016 • kawasaki 2008 Brute Force 750 NRA OUTDOORS

0helpful

1answer

Will idle & run at slow speeds, bogs down at higher speed.

Prairie 360 revs high but goes slow (45mph) - Kawasaki ATV Forum

www.kawieriders.com > ... > Kawasaki Brute Force/Prairie/Bayou
Oct 27, 2008 - 2006 Prairie 360, wife's ride, polar white, with 26" Swamp Lites on SS108's. ... that it has a low top-speed...45mph is about as fast as they seem to go. ....air cooled motor theres no real performance there, the P360 wts are light ... Can't put 2005 Kawasaki KVF 360 into gear
Jun 30, 2013
Prairie 360 speed/power issue?
Aug 28, 2012
06 Prairie 360, too many rpms???
Nov 30, 2011
2004 Prairie 360: WOT miss
Nov 9, 2011
More results from www.kawieriders.com

Read full answer

Oct 08, 2015 • kawasaki 2005 Prairie 360

0helpful

1answer

What is wrong with my 2008 kawasaki brute force 750 atv? when i hit full throttle it bogs down spits and sputters and backfires some days i can only go 6 mph it has no power at all?

sounds like you for a fuel problem like floosing crankcase with fuel, is it FI or carb

If you need further help, reach me via phone at https://www.6ya.com/expert/allen_b068623c5003aa4b

Read full answer

Aug 19, 2014 • kawasaki 2008 Brute Force 750 4x4i

0helpful

1answer

Why does my 650 brute force pa pa at low speed or down hill

Sounds like bad gas or water in the gas. Could be needing rebuild in the carbs. Start by trying some sea foam in your gas tank.

Read full answer

May 28, 2014 • kawasaki 2008 Brute Force 650 4x4i

1helpful

1answer

I have a 2009 Kawasaki Brute Force 750 with a 840 kit not starting all it does it make a clicking sound, Changed Battery and starter still make same noise. Oil light and belt light is on any advise as to...

replace starter n check chargin system

Read full answer

Aug 08, 2013 • kawasaki 2009 Brute Force 750 4x4i

0helpful

1answer

Kawasaki atv

There is a video on Youtube
15# How to reset belt light - Kawasaki brute force 750i

Read full answer

Jun 19, 2013 • ATVs

Not finding what you are looking for?

View Most Popular

2006 ZZR 1400

Motorcycles

Kawasaki KVF Brute Force 700 with electric start won't start. Cleaned the carb, changed spark plug, and checked for spark. The plug is wet but will not start.

kawasaki 2005 Brute Force 750 4x4i

553 views

Ask a Question

Usually answered in minutes!

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for 2006 kawasaki ZZR 1400? Or just drag it here!

Related Topics:

Electric start cliking, lights flicker when running