Question about 2002 Suzuki VL 800 Volusia

1 Answer

When you pull throttle back to go it kinda wants to stall but then takes off what could be doing this

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 376 Answers

Sounds like the excellartor pump diephram is sticking or has a hole in it. Also a good carb cleaning would not hurt.

Posted on Nov 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

06ford escapexlt stalls when warmed up at stop

I can tell you a possibility my friend. When first started, the computer puts the system into "cold start mode", kinda like putting on the choke you might say. Once warmed, you normally take the choke, the computer is supposed to take it out of "cold start mode" and stop putting extra fuel into the engine. If the temperature sending unit is faulty, the computer doesn't get this message and keeps dumping the fuel to it causing the stall when you let off the throttle. I'm not saying that is your situation, but that temp sending unit is what I'd be checking. Good day.

Aug 25, 2017 | Cars & Trucks

1 Answer

My 2007 pontiac grand prix seems to be having some misfire. When warming my car its kind of a rough idling and also when driving. Its seems like it wants to cut off and kinda stalls when pulling off.

Sensors dude.... O2, Water temp, Air charge, Power steering pressure switch, Idle speed control solenoid, throttle position sensor..............SPARK PLUGS & FUEL FILTER....

Mar 22, 2017 | Pontiac Cars & Trucks

1 Answer

Engine stalls but starts right back up

tune up time?
stalls, are cause by 5 major systems fail, (50 causes)
so i have only these questions.
1: can you save the stall with the fast right foot.
???????? was it very easy, kinda hard, or I can;t
dies WOT save the stall, wot -= wide open throttle (yes, pedal to the metal,

Jan 24, 2014 | Jeep Wrangler Cars & Trucks

1 Answer

When I accelerate my 2002 trailblazer it kinda stalls then kicks in later is it the throttle body or a sensor or?

Do you have the check engine light on at any time? If so, you need to get the codes scanned and make note of what the codes are.
It's possible the accelerator pedal sensor has a dead spot in it, causing the hesitation. It probably would be a good idea to have the throttle body cleaned (front side and back side).

Aug 20, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

How do i turn it on

Depending on what kinda saw it is some have an on/off switch and some you just pull trigger lock and throttle up together and move the lever to choke position which activates switch and pull over till it snorts once then back off the lever 1 click and pull again till it starts, keep in mind when it starts it will be about 1/4 to 1/3 throttle so you will have to squeeze the trigger to release the fast throttle starting position, then to shut off just slide the lever one more click and it turns off, Hope I answered Your Question

Apr 25, 2011 | Garden

1 Answer

I have a 2000 chrysler cirrus. I just got the water pump and the timing belt replaced. It was running a little low on fuel which kinda makes me think it sucked up trash. It is now missing at an idle and...

if the check engine light is on then take it to a DIFFERENT shop and have them pull the codes, have them document them (if they refer to the timing belt, you will be looking for codes that have CKT or CMT in the diagnostic code). if that's the case then take it back to the garage that did the work. and let them know that they need to take it back apart and correct the belt timing, and also have them test for bent valves ( it's called a cylinder leak down test) this should all be FREE of charge if they want ot keep you as a customer.

Apr 18, 2011 | 2000 Chrysler Cirrus

3 Answers

2003 Chevy Sliverado 4.8l V-8 stalls at stop sign, but restarts. No idiot lights

You may have a bad fuel pump sock or you may have a plugged catilatic converter, does the truck take a long time to start after it stalls out?

Jun 15, 2009 | 2003 Chevrolet Silverado 1500

1 Answer

1996 VW T4 2 litre Petrol Transpoter, fuel mixture problems

usually black smoke is a good indication of a blown head gasket check the oil to see if it look milky will look kinda brownish like chocolate milk or cocoa

Apr 11, 2009 | 1996 Volkswagen Golf

3 Answers

Honda cfr 150 f, will start but when I turn the throttle it stall

It sounds like a fuel problem. Drain the fuel tank, take the air filter off and spray some carburetor cleaner into the throttle bore, and make sure that the air and vacuum lines are clear and undamaged. Refill the tank with fresh gas and try it again.

Apr 03, 2009 | 2004 Honda CRF 150 F

Not finding what you are looking for?
2002 Suzuki VL 800 Volusia Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

76682 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides