Location oil plug 2000 harkey sportster - XL 1200 L Sporster Low Harley Davidson Motorcycles

Lay down to the floor on the right side and watch under the frame(rear) for a black hose and a plug held by a Serflex.

have you tested the coils?

It's probably not a plug. Lood for a short hose on the left side of the bike down low back behind the primary cover. It looks like it plugged onto the frame. It will probably have a different hose clamp than the rest of the hose connections. Simply pull the hose off and the oil runs out of the tank.

Good luck
Steve

Look on the left side of the bike somewhere below the battery and behind the primary cover. You'll see a hose with a plug in it or a hose that simply plugs onto a stub on the frame way down low on the frame.

Good Luck
Steve

Most of the old ironheads have a "level screw" in the side of the outer primary cover. It's located near the bottom front of the case and is usually a phillips head screw. Stand the bike up straight and remove this screw and the round access plug at the top of the cover. Pour oil in until it starts to run out the "oil level hole". It takes about a quart of oil if the primary has been drained. Use H-D Primary lube for Sportsters in this case. Good Luck Steve

Look on the right side of your bike down under the battery. You should see a hose with a "spring clamp" on it. Squeeze the clamp and pull the hose off of the lug on the frame to drain your oil tank. Helps if the oil is warm.

There is a hose between the down tubes at he rear of the frame that looks is attached to the frame, it looks like it is sending fluid into the frame. It isn't, it is a nibble to attach the drain line to.

there is a hose with a plug in it under the motor,it has a clamp holding the plug in remove that and hey presto out comes the oil .it is advisable to remove the dip stick in the reseviour tank to release suction pressure.

Left side, behind primary and kickstand. Line goes to post on frame. 3 qt oil. DO NOT USE SYNTHETICS IN ANY HARLEYS