Question about Suzuki GSX-R 1000 Motorcycles

1 Answer

Will not rev over 8000-9000 rpm in any gear? this realy sucks. please help.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 4 Answers

You need a valve adjustment. Don't run the bike you might damage the cylinder. It probably dies at an idle sometimes?

Posted on Nov 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mazda drifter 2.5 D don't rev over 3000 rpm and don't go over 120 km when its in 5th gear,its like limiting.What can it be it never did it?


When you rev the engine and does not go over 3000 rpm is this in neutral or when driving in gear? Some vehicles have a rev limiter to not allow rpm over certain point when in neutral gear but is typically not limited when driving vehicle. This sounds like a very low rev limit but not abnormal if you can get engine to rev higher when driving. You call a drifter so truck must be non US market. Is this engine a 2.5 liter diesel 4 cylinder motor. Might just be your top rev and speed if this is the case.

Nov 21, 2015 | Mazda Cars & Trucks

1 Answer

Does not want to rev up after starting.


Question: Wildcat Dealers, Pin Numbers, and Cut Outs. - ArcticChat ...

www.arcticchat.com > ... > Side by Sides > Wildcat
Apr 6, 2012 - 4 posts - ‎3 authors My gear selector is messed up and reading "E" in Park and Low gear. ... Before then it would only rev to 4500 rpm. ... exceed before it is sold, the machine goes into limp mode and will not go above 4500 rpm. ... how remove limp code for 2014 arctic cat wildcat ... how to reset codes on 2012 wildcat 1000. Rpm redline
8 posts
Feb 22, 2012
Removing rollers from a T-Cat clutch
10 posts
Aug 10, 2010
How to get rid of reverse rev limiter 700EFI/650H1 ...
10 posts
Jul 23, 2007
I can't get my ATV past 15 mph!! Help! - Page 3
10 posts
Jan 8, 2005
More results from www.arcticchat.com

Oct 02, 2015 | Arctic Cat 2014 Wildcat 1000

1 Answer

96 SAFARI IN GEAR ROUGH IDLE, NOW WONT START AT


on your discription,i would say someone has not replaced a vacum pipe under the bonnet,or placed the wrong vacum pipe on the wrong pipe if you know what i mean,the vacum pipes run around the engine small pipes if you pull one of you will hear a sucking noise or if you spit on your finger you should feel it ****.when you say it blew brake line what do you mean ,please tell me excatly what happened because this realy baffles me,please come back to me on this problem .adrian,,,,

Jun 28, 2010 | 1996 GMC Safari

1 Answer

When I push the gas pedal the RPM's rev really high and it takes a little time for the gear to catch.


The RPM's are revolutions per minute. So when you step on the gas, the RPM's should rev high. Not going into gear is a safety feature,

Apr 10, 2010 | 1995 Subaru Legacy

1 Answer

2004 ford f150 ranger shuts off during operation tach stays up arround 2000 rpm while in gear engine does not rev when pushing on pedal out of gear nor does the rpm change when in gear. few seconds later...


Is this a diesel?If it is check the fuel filter.If it is a gas burner,check the air flow(air filter,and filter box)for a plastic bag or paper sack sucked up in the intake duct.If this checks out fine ,have the cat.checked to see if it is stopped up.

Aug 29, 2009 | 2004 Ford F150

1 Answer

REVS TOO HIGH WHEN COLD...........


High RPM is by purpose. Reason is to get engine hot as quickly as possible to reduce emissions. There is nothing to worry about. I am sure if engine is warm/hot then you wont see high RPM even if you resart it.

Dec 15, 2008 | 2002 Toyota Corolla

1 Answer

Engine revs realy loud


You have a faulty thermostatically controlled fan clutch. Same thing happened to mine. As soon as you start the car, the fan is always turning, and the speed increases as the RPM is increased.

Oct 19, 2008 | 2006 GMC Envoy

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...