Clunking and banging combined with a slip feeling coming from the front left side of my primary

jack up and support vehicle grab top and bottom of wheel and see if its loose if loose feeling up top or clunking possible upper ball joint if bottom feel/noise poss bottom ----move wheel side to side and look and check tie rods if loose or noise inspect and replace if damaged or worn ---remove wheel and inspect the joints and tie rods if their was no noise or worn check the upper and lower control arm bushings as well as the swaybar supports and bushings

16 costly car noises - Bankrate.com

www.bankrate.com/finance/money.../16-costly-car-noises-1.asp...

BankrateYou should not ignore certain thumping, banging, clicking and squealing sounds. These sounds often rear their heads or intensify whenever the driver takes ... Hissing or sizzling under the hood: Heard when the engine is first shut off, .... my rear right wheel makes a loud bang when switching from park to drive/reverse.

Sounds coming from drivers side front wheel - AnandTech Forums

forums.anandtech.com > Social > The Garage

AnandTech
Dec 1, 2009 - 21 posts - ‎10 authors
Sounds coming from drivers side front wheel The Garage. ... slightly left, I get a slight metalish-squealing sound coming from the drivers side front wheel area. ... but before I start the wild and expensive goose chase of bringing it to mechanics I ..... Those twoloud clunks when turning hard right give it away.

Ford Explorer Questions - Thumping from front end - CarGurus

www.cargurus.com > Questions > Ford > Explorer

CarGurusDec 22, 2009 - Thumping from front end - I have a hard thumping noise coming from ... without problem then I'll take a turn or something and it will start. ... I just recentlystarted having a rubbing and thumping and squeaking noise in the right front sidewhen driving ... Thumping sound coming from under the truck 4 answers.

Car Noises: Consumer Reports - Consumer Reports Online

www.consumerreports.org/cro/...noises/.../index.htm

Consumer Reports

go to the magicmechanic website and send him this--hes the best there is and will rply

may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: spobd2.com

This is a simple repair. The main spring may have come loose from the top (need to check the top two springs ny removing top panel. The reaslon it bangs is from the dampeners being broke. Take off the bottom panel and look inside left and right at the bottom to see if the dampeners are broke. Fairly easy repair - takes some muscle. John<!-- from fixya rte -->

Probably not, but possible. Sportys do clunk a bit when shifting gears. As long as it's not a huge bang, it should be OK. Using different trans/primary fluid may help. As for the whine, I would remove the primary chaincase cover and make sure your primary chain is adjusted properly. 5/8 to 7/8 slack at the tightest sopt. Adjust the clutch as per service manual instructions too. Dragging clutch will make for a hard shift. Check ALL nuts and bolts for tightness and look for bent parts. There is a VERY remote possibilty that when you went down and the shifter hit the ground you bent a shift fork, but like I said it's a remote possibility.

Could be a loose compensator nut. Holding the front brake with the bike in gear, slowly release the clutch lever to see if you can recreate the clunking noise right there. It will be on the front left of the primary cover. If you can hear it ( and you might be able to feel it too ) then that is the route I would go.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Check your primary chain. Don't know if it is, my 07 used to do the same - feels like something hitting more on the left side.

it is compressor shutting off,not much you can do to fix it.you can try changing the snubbers that hold it in place but most likely you will still hear it clunk.

sounds as if hte lid switch is not activating correctly, the lid actuator is actulle hte under side of left hand door hinge. if you lkift the lid and feel under the left side og the lid you fell the metal lid hinge, simply slip a hollow shafted screwdriver over the hingeitself and bend slightly back, this will make the lid come in contact with swict a little bit easier